C8051F902-GM Silicon Laboratories Inc, C8051F902-GM Datasheet - Page 174

• Manufacturer Part Number: C8051F902-GM
• Description: IC MCU 8BIT 8KB FLASH 24QFN
• Manufacturer: Silicon Laboratories Inc
• Series: C8051F9xxr

Specifications of C8051F902-GM

• Program Memory Type: FLASH
• Program Memory Size: 8KB (8K x 8)
• Package / Case: 24-QFN
• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 25MHz
• Connectivity: SMBus (2-Wire/I²C), SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, Temp Sensor, WDT
• Number Of I /o: 16
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 0.9 V ~ 3.6 V
• Data Converters: A/D 15x10/12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Processor Series: C8051F9x
• Core: 8051
• Data Ram Size: 768 B
• Interface Type: UART
• Maximum Clock Frequency: 25 MHz
• Number Of Timers: 4
• Operating Supply Voltage: 0.9 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: C8051F912DK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 12 bit
• Package: 24QFN EP
• Device Core: 8051
• Family Name: C8051F90x
• Maximum Speed: 25 MHz
• Data Bus Width: 8 Bit
• Number Of Programmable I/os: 16
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1848-5

C8051F91x-C8051F90x
Important Notes:
•
•
•
174
The Power-on Reset (POR) delay is not incurred after a VDD/DC+ supply monitor reset. See Section
“4. Electrical Characteristics” on page 36 for complete electrical characteristics of the VDD/DC+ moni-
tor.
Software should take care not to inadvertently disable the V
to RSTSRC to enable other reset sources or to trigger a software reset. All writes to RSTSRC should
explicitly set PORSF to 1 to keep the V
The VDD/DC+ supply monitor must be enabled before selecting it as a reset source. Selecting the
VDD/DC+ supply monitor as a reset source before it has stabilized may generate a system reset. In
systems where this reset would be undesirable, a delay should be introduced between enabling the
VDD/DC+ supply monitor and selecting it as a reset source. See Section “4. Electrical Characteristics”
on page 36 for minimum VDD/DC+ Supply Monitor turn-on time. No delay should be introduced in
systems where software contains routines that erase or write Flash memory. The procedure for
enabling the VDD/DC+ supply monitor and selecting it as a reset source is shown below:
1. Enable the VDD/DC+ Supply Monitor (VDMEN bit in VDM0CN = 1).
2. Wait for the VDD/DC+ Supply Monitor to stabilize (optional).
3. Select the VDD/DC+ Supply Monitor as a reset source (PORSF bit in RSTSRC = 1).
DD
Monitor enabled as a reset source.
Rev. 1.0
DD
Monitor as a reset source when writing