S912XEQ384J3MALR Freescale Semiconductor, S912XEQ384J3MALR Datasheet - Page 937

• Manufacturer Part Number: S912XEQ384J3MALR
• Description: S912XEQ Series 16 Bit 50 Mhz 384 KB Flash 24 KB Ram Microcontroller - LQFP-112
• Manufacturer: Freescale Semiconductor

Upon clearing CCIF to launch the Verify Backdoor Access Key command, the Memory Controller will
check the FSEC KEYEN bits to verify that this command is enabled. If not enabled, the Memory
Controller sets the ACCERR bit in the FSTAT register and terminates. If the command is enabled, the
Memory Controller compares the key provided in FCCOB to the backdoor comparison key in the Flash
configuration field with Key 0 compared to 0x7F_FF00, etc. If the backdoor keys match, security will be
released. If the backdoor keys do not match, security is not released and all future attempts to execute the
Verify Backdoor Access Key command are aborted (set ACCERR) until a reset occurs. The CCIF flag is
set after the Verify Backdoor Access Key operation has completed.
25.4.2.13 Set User Margin Level Command
The Set User Margin Level command causes the Memory Controller to set the margin level for future read
operations of a specific P-Flash or D-Flash block.
Upon clearing CCIF to launch the Set User Margin Level command, the Memory Controller will set the
user margin level for the targeted block and then set the CCIF flag.
Valid margin level settings for the Set User Margin Level command are defined in
Freescale Semiconductor
FERSTAT
Register
FSTAT
CCOBIX[2:0]
Table 25-57. Set User Margin Level Command FCCOB Requirements
Table 25-56. Verify Backdoor Access Key Command Error Handling
000
001
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Error Bit
FPVIOL
(CCOBIX=001)
Table 25-58. Valid Set User Margin Level Settings
0x0000
0x0001
CCOB
MC9S12XE-Family Reference Manual Rev. 1.24
Set if CCOBIX[2:0] != 100 at command launch
Set if a Load Data Field command sequence is currently active
Set if an incorrect backdoor key is supplied
Set if backdoor key access has not been enabled (KEYEN[1:0] != 10, see
Section
Set if the backdoor key has mismatched since the last reset
None
None
None
None
0x0D
25.3.2.2)
Return to Normal Level
User Margin-1 Level
FCCOB Parameters
Margin level setting
Level Description
Global address [22:16] to identify the
Error Condition
Chapter 25 256 KByte Flash Module (S12XFTM256K2V1)
(1)
Flash block
Table
25-58.
937