Z8018010PSG Zilog, Z8018010PSG Datasheet - Page 90

• Manufacturer Part Number: Z8018010PSG
• Description: IC 10MHZ Z180 CMOS ENH MPU 64DIP
• Manufacturer: Zilog

Specifications of Z8018010PSG

• Processor Type: Z180
• Features: 8-Bit, Enhanced Z80 Megacell
• Speed: 10MHz
• Voltage: 5V
• Mounting Type: Through Hole
• Package / Case: 64-DIP (0.750", 19.05mm)
• Processor Series: Z8018xx
• Core: Z80
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 10 MHz
• Number Of Timers: 2
• Operating Supply Voltage: 0 V to 5 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: Through Hole
• Minimum Operating Temperature: 0 C
• Core Size: 8bit
• Cpu Speed: 10MHz
• Digital Ic Case Style: DIP
• No. Of Pins: 64
• Supply Voltage Range: 4.5V To 5.5V
• Operating Temperature Range: 0°C To +70°C
• Svhc: No SVHC (18-Jun-2010)
• Base Number: 8018010
• Rohs Compliant: Yes
• Clock Frequency: 10MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-3889; Z8018010PSG

Figure 35.
INT0 - Maskable Interrupt Level 0
The next highest priority external interrupt after NMI is INT0. INT0 is
sampled at the falling edge of the clock state prior to T3 or T1 in the last
machine cycle. If INT0 is asserted LOW at the falling edge of the clock
state prior to T3 or T1 in the last machine cycle, INT0 is accepted. The
interrupt is masked if either the IEF1 flag or the ITEO (Interrupt Enable
0) bit in ITC are reset to
1. IEF1 is
2. ITE0 is
The INT0 interrupt is unique in that 3 programmable interrupt response
modes are available - Mode 0, Mode 1 and Mode 2. The specific mode is
selected with the IM 0, IM 1 and IM 2 (Set Interrupt Mode) instructions.
During RESET, the Z8X180 is initialized to use Mode 0 for INT0. The 3
interrupt response modes for INT0 are:
•
•
•
INT0 Mode 0
During the interrupt acknowledge cycle, an instruction is fetched from the
data bus (DO–D7) at the rising edge of T3. Often, this instruction is one
of the eight single byte RST (RESTART) instructions which stack the PC
and restart execution at a fixed logical address. However, multibyte
instructions can be processed if the interrupt acknowledging device can
provide a multibyte response. Unlike all other interrupts, the PC is not
automatically stacked:
Interrupts) instruction
Mode 0–Instruction fetch from data bus
Mode 1–Restart at logical address
Mode 2–Low-byte vector table address fetch from data bus
0
1
NMI Timing
, so INT0 is masked
, so INT0 is enabled by execution of the El (Enable
0
. After RESET the state is as follows:
0038H
Family MPU User Manual
UM005003-0703
Z8018x
75