DS26514G Maxim Integrated, DS26514G Datasheet - Page 212

• Manufacturer Part Number: DS26514G
• Description: Network Controller & Processor ICs
• Manufacturer: Maxim Integrated

Specifications of DS26514G

• Part # Aliases: 90-26514-G00

Register Name:
Register Description:
Register Address:
Bit #
Name
Default
Bit 7: Framer Enable (FRM_EN). This bit must be set to the desired state before writing INIT_DONE.
Bit 6: Initialization Done (INIT_DONE). The user must set this bit once he has written the configuration registers.
The host is required to write or clear all device registers prior to setting this bit. Once INIT_DONE is set, the
DS26514 will check the FRM_EN bit and, if enabled, will begin operation based on the initial configuration.
Bit 1: Soft Reset (SFTRST). Level sensitive “soft” reset. Should be taken high, then low to reset the transceiver.
Note: This reset does not clear the registers.
Bit 0: Transmitter T1/E1 Mode Select (T1/E1). Sets operating mode for transmitter only! This bit must be written
with the desired value prior to setting INIT_DONE.
19-5856; Rev 4; 5/11
0 = Framer disabled—held in low-power state.
1 = Framer enabled—all features active.
0 = Normal operation.
1 = Reset the transceiver.
0 = T1 operation.
1 = E1 operation.
FRM_EN
7
0
INIT_DONE
TMMR
Transmit Master Mode Register
180h + (200h x (n - 1)) : where n = 1 to 4
6
0
—
5
0
—
4
0
—
3
0
DS26514 4-Port T1/E1/J1 Transceiver
—
2
0
SFTRST
1
0
212 of 305
T1/E1
0
0