IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 205

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

Boot Monitor Console Commands—IXB2850
A.2.58
A.2.59
January 2007
Document Number: 05-2443-006
Example
post bmc -a
post config
Set the verbose output for POST tests and internal UART baud rate.
Syntax
post config -h | -v <level> -b <baud rate> -d
Parameters
Example
post config -v 3
post ethpci
Perform PCI Ethernet tests. These tests check for the presence of an Ethernet chip,
registers access and sends/receives test packets.
Syntax
post ethpci -h | -a | -f -r -i -m -e -n <port>
Parameters
• -h - Display help screen
• -h - Display help screen
• -v <level> - Specify verbose level; possible values are:
• -b <baud> - Changes the internal UART board rate
• -d - Return the above values to their default settings
• -f - Checks if an Ethernet device is present on board
• -i - Run Ethernet interrupt test
• -r - Run register access test
• -m - Run MAC (internal) loopback test
• -e - Run external system loopback test
• -a - Test all (except for external loopback test)
• -h - Display help screen
• -n <port> - Specify Ethernet PCI port number; one of the following:
— 0 - No console output
— 1 - Minimal console output. This is the default value.
— 2 - Individual errors from each test are output to the console
— 3 - Individual warnings from each test are output to the console
— 4 - Prints debug information
— 5 - Prints all debug information
— 0 - Port 0
— 1 - Port 1
Intel NetStructure
®
IXB2850 Packet Processing Boards
TPS
205