IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 19

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

Getting Started—IXB2850
Note:
Note:
2.4.1.2
January 2007
Document Number: 05-2443-006
The configuration of the Fast Ethernet interface is given as an example and can be
adjusted to the local network configuration.
The BROADCAST, IPADDR and NETWORK IP addresses of the Gigabit Ethernet port are
given as an example and can be adjusted to the user configuration.
Serial Ports
The Management PC serial ports connected to the console ports of the IXB2850 board
(NP and/or BMC) should be set to operate in the following configuration:
The
serial terminal application. The configuration procedure for the
given below:
2. Configure the Gigabit Ethernet interface by editing the
3. Cycle the eth0 and eth1 interface:
1. Run the Linux minicom.
2. Configure the serial port parameters in
3. Configure the serial port parameters in minicom as follows:
• 115,200 baud
• 8 bits, no parity, 1 stop bit
• Hardware and software flow control disabled
network-scripts/ifcfg-eth1
the Gigabit Ethernet interface is named eth1. The name of the interface may differ
depending the hardware configuration.
a. Press Ctrl-A O and select the Serial port setup option.
b. Specify the serial port device, for example,
c.
d. Set Software and Hardware Flow Control to No.
a. Press Ctrl-A O, select Filenames and paths and specify the script directory
BOOTPROTO=static
BROADCAST=10.69.255.255
IPADDR=10.69.22.253
NETMASK=255.255.0.0
NETWORK=10.69.0.0
ONBOOT=yes
# IXB2850-specific
DEVICE=eth1
BOOTPROTO=static
BROADCAST=172.255.255.255
IPADDR=172.0.0.10
NETMASK=255.0.0.0
NETWORK=172.0.0.0
ONBOOT=yes
#/sbin/ifdown eth0
#/sbin/ifup eth0
#/sbin/ifdown eth1
#/sbin/ifup eth1
minicom
Set Bps/Par/Bits to: 115200 8N1
(option C):
/tftpboot
application, running on the Management PC, is recommended as the
file. In the following example, it is assumed that
minicom
Intel NetStructure
/dev/ttyS1
as follows:
®
/etc/sysconfig/
IXB2850 Packet Processing Boards
minicom
.
(v. 2.00.0) is
TPS
19