IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 17

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

Getting Started—IXB2850
2.2
Table 2.
2.3
Note:
Note:
Note:
January 2007
Document Number: 05-2443-006
IXB2850 Board Hardware Configuration
IXB2850 boards must be configured for the desired mode of IPMI operation. The
possible modes of operation and the corresponding settings for jumper J2 on the
IXB2850 board are given in
locations” on page 75
Setup for IPMI
System Components Connection
The connection of components in a basic system that contains an IXB2850 board is
shown in
The grayed elements in
To perform the IXB2850 system hardware setup, proceed as follows:
The debug console cable, IXB3GDEBUGCABLE, a separately orderable item that
connects to the COM port on IXB2850 boards provides serial interface connections (DB-
9 connectors) for both the NP console and the BMC console. See
“Debug Console Cable Specification” on page 165
The NP and BMC console port from the IXB2850 point of view is the same port (named
CONSOLE). See
more information.
Mode
PICMG 3.0
Legacy
BMC power
control disabled
1. Configure the AdvancedTCA chassis and the Switch Fabric boards according to
2. Insert the IXB2850 board, Shelf Management Controller (ShMC) and the Switch
3. Set up the connections between the IXB2850 boards, Ethernet hub, and the
4. Connect the IXB2850 board debug Ethernet port to the Ethernet hub.
vendors’ documentation.
Fabric boards in the chassis. Take into consideration that some AdvancedTCA
chassis allocate specific slots for Switch Fabric boards and an IXB2850 board should
not be placed in those locations.
Management PC as follows:
a. Connect the Management PC Fast Ethernet interface to the Ethernet hub.
b. Connect the Management PC Gigabit Ethernet interface to the Switch Fabric
c.
d. Connect the Management PC serial port to the IXB2850 board BMC console port.
board uplink Ethernet port.
Connect the Management PC serial port to the IXB2850 board NP console port.
Figure
Description
IPMI support for
PICMG 3.1 ShMC
No ShMC installed or
no PICMG 3.1 shelf
manager used
The BMC does not control
power on the board
6.
Section 12.8.1, “Debug Console Cable Specification” on page 165
for the location of jumper J2 on IXB2850 boards.
Figure 6
Table
are optional for some development/usage scenarios.
2. See
Jumper
Settings
J2: 1-2 – ON
J2: 15-17 – ON
J2: 1-2 – OFF
J2: 15-17 – ON
J2: 15-16 – ON
Figure 27, “IXB2850 jumper and switch
Intel NetStructure
for more information.
Notes
The default (recommended) mode
Should only be used when the PICMG 3.0
shelf manager is not available
Not recommended for normal operation and
should only be used for service.
Can be used temporarily to boot the board
when the onboard BMC is damaged.
®
IXB2850 Packet Processing Boards
Section 12.8.1,
for
TPS
17