h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 914

• Manufacturer Part Number: h8s-2635
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 21B ROM (H8S/2638 Group, H8S/2639 Group, H8S/2630 Group)
21B.13.9 Notes on Memory Programming
1. When programming addresses which have previously been programmed, carry out auto-
2. When performing programming using programmer mode on a chip that has been
Notes: 1. The flash memory is initially in the erased state when the device is shipped by Renesas
Rev. 6.00 Feb 22, 2005 page 854 of 1484
REJ09B0103-0600
erasing before auto-programming.
programmed/erased in an on-board programming mode, auto-erasing is recommended before
carrying out auto-programming.
4-5
Figure 21B-25 Oscillation Stabilization Time, Boot Program Transfer Time, and
2. Auto-programming should be performed once only on the same address block.
Technology. For other chips for which the erasure history is unknown, it is
recommended that auto-erasing be executed to check and supplement the initialization
(erase) level.
Additional programming cannot be performed on previously programmed address
blocks.
Power-Down Sequence