h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 749

no-image

h8s-2635

Manufacturer Part Number
h8s-2635
Description
Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
Manufacturer
Renesas Electronics Corporation.
Datasheet
17.6
The following points should be noted when using the A/D converter.
Setting Range of Analog Power Supply and Other Pins:
(1) Analog input voltage range
(2) Relation between AVCC, AVSS and VCC, VSS
(3) Vref input range
If conditions (1), (2), and (3) above are not met, the reliability of the device may be adversely
affected.
Notes on Board Design: In board design, digital circuitry and analog circuitry should be as
mutually isolated as possible, and layout in which digital circuit signal lines and analog circuit
signal lines cross or are in close proximity should be avoided as far as possible. Failure to do so
may result in incorrect operation of the analog circuitry due to inductance, adversely affecting A/D
conversion values.
Also, digital circuitry must be isolated from the analog input signals (AN0 to AN11), analog
reference power supply (Vref), and analog power supply (AVCC) by the analog ground (AVSS).
Also, the analog ground (AVSS) should be connected at one point to a stable digital ground (VSS)
on the board.
Notes on Noise Countermeasures: A protection circuit connected to prevent damage due to an
abnormal voltage such as an excessive surge at the analog input pins (AN0 to AN11) and analog
reference power supply (Vref ) should be connected between AVCC and AVSS as shown in
figure 17-7.
Also, the bypass capacitors connected to AVCC and Vref and the filter capacitor connected to
AN0 to AN11 must be connected to AVSS.
If a filter capacitor is connected as shown in figure 17-7, the input currents at the analog input pins
(AN0 to AN11) are averaged, and so an error may arise. Also, when A/D conversion is performed
frequently, as in scan mode, if the current charged and discharged by the capacitance of the
The voltage applied to analog input pin ANn during A/D conversion should be in the range
AVSS ANn
As the relationship between AVSS and VSS, set AVSS = VSS. If the A/D converter is not
used, set AVCC = VCC, and do not leave the AVCC and AVSS pins open or no account.
The analog reference voltage input at the Vref pin set in the range Vref
Usage Notes
Vref.
Rev. 6.00 Feb 22, 2005 page 689 of 1484
Section 17 A/D Converter
AVCC.
REJ09B0103-0600

Related parts for h8s-2635