h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 722

no-image

h8s-2635

Manufacturer Part Number
h8s-2635
Description
Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
Manufacturer
Renesas Electronics Corporation.
Datasheet
Section 16 Controller Area Network (HCAN)
HCAN sleep mode is entered by setting the HCAN sleep mode bit (MCR5) to 1 in the master
control register (MCR). If the CAN bus is operating, the transition to HCAN sleep mode is
delayed until the bus becomes idle.
Either of the following methods of clearing HCAN sleep mode can be selected by making a
setting in the MCR7 bit.
1. Clearing by software
2. Clearing by CAN bus operation
Eleven recessive bits must be received after HCAN sleep mode is cleared before CAN bus
communication is enabled again.
Clearing by software: HCAN sleep mode is cleared by writing a 0 to MCR5 from the CPU.
Clearing by CAN bus operation: Clearing by CAN bus operation occurs automatically when the
CAN bus performs an operation and this change is detected. In this case, the first message is not
received in the mailbox, and normal reception starts from the next message. When a change is
detected on the CAN bus in HCAN sleep mode, the bus operation interrupt flag (IRR12) is set in
the interrupt register (IRR). If the bus interrupt mask (IMR12) in the interrupt mask register (IMR)
is set to the interrupt enable value at this time, an interrupt can be sent to the CPU.
Rev. 6.00 Feb 22, 2005 page 662 of 1484
REJ09B0103-0600

Related parts for h8s-2635