FX1S-30MR-ES/UL MITSUBISHI, FX1S-30MR-ES/UL Datasheet - Page 363

• Manufacturer Part Number: FX1S-30MR-ES/UL
• Description: PLC, 16 IN, 14 RELAY OUT, 110V/2
• Manufacturer: MITSUBISHI

Specifications of FX1S-30MR-ES/UL

• No. Of Analogue Inputs: 16
• No. Of Analogue Outputs: 14
• Ip/nema Rating: IP10
• Approval Bodies: CE, CUL, UL
• External Depth: 49mm
• External Length / Height: 90mm
• External Width: 60mm
• Mounting Type: Panel

10.19.4 Specified device monitor
FX Series Programmable Controllers
It is possible to specify in the PLC, the devices to be displayed on the 5DM.
When specifying a device to be displayed, write the correcponding number shown in the table
below to D .
*1 If a numeric value other than 1~9 is writen, no device will be specified. In this case all
operator functions are valid.
Points to note:
a)During the monitoring of devices T or C, if a device number not used in the program is
b)When scrolling and displaying consecutive devices using the operation keys, move up and
c)If the device numbers are not consecutive, and scrolling is required, some additional PLC
d)If data registers used in D8158 are located in the non-backup area, the current values of the
specified, the next largest existing device number is displayed. If the specified device
number is beyond the range available, the largest existing device number will be displayed.
If the OUT instruction for the T or C is not present in the sequence program, ‘----’ is displayed
on the 5DM screen.
down the range with the [+] and [-] keys.
code will be needed. The range of device numbers to be displayed will have to be related to
an index register, the [+] and [-] keys increment and decrement the current value of this
register, and therefore change the displayed values.
data registers are reset to ‘0’ when the PLC is stopped. As a result of this, the device type to
be displayed, set by
In order to disable the operator functions, use data registers located in a battery backed
area.
Current value of
Any other value
1
2
3
4
5
6
7
8
9
D
D
becomes invalid and, the operator functions become valid.
Input (X)
Output (Y)
Auxiliary relay (M)
State (S)
Timer (T)
Counter (C), 16-bit current and set value or 32-bit set value
Data register (D) 16-bit
Data register (D) 32-bit
Time display
Not used *1
Device type
Points Of Technique 10
10-31