FX1S-30MR-ES/UL MITSUBISHI, FX1S-30MR-ES/UL Datasheet - Page 141

• Manufacturer Part Number: FX1S-30MR-ES/UL
• Description: PLC, 16 IN, 14 RELAY OUT, 110V/2
• Manufacturer: MITSUBISHI

Specifications of FX1S-30MR-ES/UL

• No. Of Analogue Inputs: 16
• No. Of Analogue Outputs: 14
• Ip/nema Rating: IP10
• Approval Bodies: CE, CUL, UL
• External Depth: 49mm
• External Length / Height: 90mm
• External Width: 60mm
• Mounting Type: Panel

5.2.5
FX Series Programmable Controlers
Operation 2: (Applicable units, FX
allows BCD numbers to be manipulated in exactly the same way as the ‘normal’ SMOV
manipulates decimal numbers, i.e. This instruction copies a specified number of digits from a 4
digit BCD source (S) and places them at a specified location within a destination (D) number
(also a 4 digit BCD number).
CML (FNC 14)
This means each occurrence of a ‘1’ in the source data will become a ‘0’ in the destination data
while each source digit which is ‘0’ will become a ‘1’. If the destination area is smaller than the
source data then only the directly mapping bit devices will be processed.
CML
FNC 14
(Compli-
ment)
General note:
For more information about ‘decimal’ and ‘Binary Coded Decimal’ (BCD) numbers please
see the section titled ‘Interpreting Word Data’ on page 4-42 for more details.
Mnemonic
Copies and
inverts the source
bit pattern to a
specified
destination
Function
K, H,
KnX, KnY, KnM, KnS,
T, C, D, V, Z
2N
and FX
Operation:
A copy of each data bit within the source device (S) is
inverted and then moved to a designated destination
(D).
S
To select the BCD mode the SMOV instruction is
coupled with special M coil M8168 which is driven
ON. Please remember that this is a ‘mode’ setting
operation and will be active, i.e. all SMOV
instructions will operate in BCD format until the
mode is reset, i.e. M8168 is forced OFF.
2NC
Operands
). This modification of the SMOV operation
KnY, KnM, KnS,
T, C, D, V, Z
D
Applied Instructions 5
CML,CMLP:
5 steps
DCML,
DCMLP:
9 steps
Program steps
5-19