FX1S-30MR-ES/UL MITSUBISHI, FX1S-30MR-ES/UL Datasheet - Page 205

• Manufacturer Part Number: FX1S-30MR-ES/UL
• Description: PLC, 16 IN, 14 RELAY OUT, 110V/2
• Manufacturer: MITSUBISHI

Specifications of FX1S-30MR-ES/UL

• No. Of Analogue Inputs: 16
• No. Of Analogue Outputs: 14
• Ip/nema Rating: IP10
• Approval Bodies: CE, CUL, UL
• External Depth: 49mm
• External Length / Height: 90mm
• External Width: 60mm
• Mounting Type: Panel

5.8.3
FX Series Programmable Controlers
e) The HKY instruction may only be used ONCE.
f) Normal operation requires 8 scans to read the key
Operation 2 - Using the HKY Instruction With
M8167:
(Applicable units: FX
When the HKY instruction is used with flag M8167 ON
(as shown right), the operation of keys A through F
allow actual entry of the Hexadecimal values of A
through F respectively into the data device D
in addition to the standard 0 through 9 keys. All other
operation is as specified in ‘Operation 1 - Standard’.
Maximum storage values for this operation become
FFFF in 16 bit mode and FFFFFFFF in 32 bit (double
word) mode.
DSW (FNC 72)
Points to note:
a) When n = 1 only one set of switches are read. The
Continued on next page...
DSW
FNC 72
(Digital
switch)
Mnemonic
inputs. To achieve a steady and repeatable
performance, constant scan mode should be used,
i.e. M8039 is set ON and a user defined scan time
is written to register D8039. However, for a faster
r e s p o n s e t h e H K Y i n s t r u c t i o n s h o u l d b e
programmed in a timer interrupt routine as shown
in the example opposite.
multiplex is completed by wiring the thumbwheels
in parallel back to 4 consecutive inputs from the
head address specified in operand S. The (4 digit)
data read is stored in data device D
Multiplexed
reading of n sets
of digital (BCD)
thumbwheels
Function
2N
and FX
2NC
X
Note:
If n=2 then
8
devices
else 4.
)
S
2
.
Y
Note:
uses 4
consecu-
tive
devices
Operation:
This instruction multiplexes 4 outputs (D
or 2(n) sets of switches. Each set of switches
consists of 4 thumbwheels providing a single digit
input.
2
. This is
D
1
Operands
T, C, D, V,
Z
Note: If
n=2 then 2
devices
else 1.
D
2
K, H
Note:
n= 1 or 2
n
Applied Instructions 5
DSW:
9 steps
Program steps
5-83
1
) through 1