HD6413008F RENESAS [Renesas Technology Corp], HD6413008F Datasheet - Page 509

• Manufacturer Part Number: HD6413008F
• Description: Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series
• Manufacturer: RENESAS [Renesas Technology Corp]

18.4.2
Software standby mode can be exited by input of an external interrupt at the NMI, IRQ
IRQ
Exit by Interrupt: When an NMI, IRQ
clock oscillator begins operating. After the oscillator settling time selected by bits STS2 to STS0
in SYSCR, stable clock signals are supplied to the entire chip, software standby mode ends, and
interrupt exception handling begins. Software standby mode is not exited if the interrupt enable
bits of interrupts IRQ
CPU.
Exit by RES Input: When the RES input goes low, the clock oscillator starts and clock pulses are
supplied immediately to the entire chip. The RES signal must be held low long enough for the
clock oscillator to stabilize. When RES goes high, the CPU starts reset exception handling.
Exit by STBY Input: Low input at the STBY pin causes a transition to hardware standby mode.
18.4.3
Bits STS2 to STS0 in SYSCR and bits DIV1 and DIV0 in DIVCR should be set as follows.
Crystal Resonator: Set STS2 to STS0, DIV1, and DIV0 so that the waiting time (for the clock to
stabilize) is at least 7 ms. Table 18.3 indicates the waiting times that are selected by STS2 to
STS0, DIV1, and DIV0 settings at various system clock frequencies.
When Using an External Clock: Set the STS2 to STS0, DIV0, and DIV1 bits so that the waiting
time is at least 100 μs.
2
pin, or by input at the RES or STBY pin.
Exit from Software Standby Mode
Selection of Waiting Time for Exit from Software Standby Mode
0
, IRQ
1
, and IRQ
2
are cleared to 0, or if these interrupts are masked in the
0
, IRQ
1
, or IRQ
2
interrupt request signal is received, the
Rev.4.00 Aug. 20, 2007 Page 465 of 638
18. Power-Down State
REJ09B0395-0400
0
, IRQ
1
, or