r4f2456 Renesas Electronics Corporation., r4f2456 Datasheet - Page 451

• Manufacturer Part Number: r4f2456
• Description: 16-bit Single-chip Microcomputer H8s Family / H8s/2400 Series
• Manufacturer: Renesas Electronics Corporation.

Section 8 EXDMA Controller (EXDMAC)
(3)
EXDMA Transfer Count Register (EDTCR)
When a DMA transfer is performed, the value in EDTCR is decremented by 1. However, when the
EDTCR value is 0, transfers are not counted and the EDTCR value does not change.
EDTCR functions differently in block transfer mode. The upper 8 bits, EDTCR[23:16], are used to
specify the block size, and their value does not change. The lower 16 bits, EDTCR[15:0], function
as a transfer counter, the value of which is decremented by 1 when a DMA transfer is performed.
However, when the EDTCR[15:0] value is 0, transfers are not counted and the EDTCR[15:0]
value does not change.
In normal transfer mode, all of the lower 24 bits of EDTCR may change, so when EDTCR is read
by the CPU during DMA transfer, a longword access must be used. During a transfer operation,
EDTCR may be updated without regard to accesses from the CPU, and the correct values may not
be read if the upper and lower words are read separately. In a longword access, the EXDMAC
buffers the EDTCR value to ensure that the correct value is output.
In block transfer mode, the upper 8 bits are never updated, so there is no problem with using word
access.
Do not write to EDTCR for a channel on which a transfer operation is in progress. If there is
contention between an address update associated with DMA transfer and a write by the CPU, the
CPU write has priority.
In the event of contention between an EDTCR update from 1 to 0 and a write (of a nonzero value)
by the CPU, the CPU write value has priority as the EDTCR value, but transfer is terminated.
Transfer does not end if the CPU writes 0 to EDTCR.
Figure 8.11 shows EDTCR update operations in normal transfer mode and block transfer mode.
Rev. 1.00 Sep. 19, 2008 Page 421 of 1342
REJ09B0467-0100