r4f2456 Renesas Electronics Corporation., r4f2456 Datasheet - Page 1078

• Manufacturer Part Number: r4f2456
• Description: 16-bit Single-chip Microcomputer H8s Family / H8s/2400 Series
• Manufacturer: Renesas Electronics Corporation.

Section 18 A/D Converter
18.7.6
If the conditions shown below are not met, the reliability of the LSI may be adversely affected.
• Analog input voltage range
• Relation between AVcc, AVss and Vcc, Vss
• Vref setting range
18.7.7
In board design, digital circuitry and analog circuitry should be as mutually isolated as possible,
and layout in which digital circuit signal lines and analog circuit signal lines cross or are in close
proximity should be avoided as far as possible. Failure to do so may result in incorrect operation
of the analog circuitry due to inductance, adversely affecting A/D conversion values.
Digital circuitry must be isolated from the analog input pins (AN0 to AN15*), analog reference
power supply (Vref), and analog power supply (AVcc) by the analog ground (AVss). Also, the
analog ground (AVss) should be connected at one point to a stable ground (Vss) on the board.
Note: * In the H8S/2454 group, only AN0 to AN7, AN12, and AN13 are available as analog
Rev. 1.00 Sep. 19, 2008 Page 1048 of 1342
REJ09B0467-0100
The voltage applied to analog input pin ANn during A/D conversion should be in the range
AVss ≤ V
As the relationship between AVcc, AVss and Vcc, Vss, set AVcc = Vcc ± 0.3 V and AVss =
Vss. If the A/D converter is not used, set AVcc = Vcc and AVss = Vss.
The reference voltage at the Vref pin should be set in the range Vref ≤ AVcc.
Setting Range of Analog Power Supply and Other Pins
Notes on Board Design
input pins.
AN
≤ Vref.