3F88L-CR002C Omron, 3F88L-CR002C Datasheet - Page 147

• Manufacturer Part Number: 3F88L-CR002C
• Description: CABLE RESOLVER FOR RS17/T 2M
• Manufacturer: Omron

Specifications of 3F88L-CR002C

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 3F88LCR002C

Operation
H Adjustment Operation (RUN Mode)
D Outline of Operation
10. The message “Do you want to adjust another cam number?” will appear.
11. Press any key other than the Up, Down, or Set Keys to exit the procedure.
D Procedure
1. Change to RUN mode.
2. Press the Set Key while press the Up and Down Keys to enable the adjustment operation function.
3. Use the Up and Down Keys to set the cam number to be adjusted.
4. Press the Set Key.
5. Adjust the ON angle using the Up and Down Keys.
6. Adjust the OFF angle by pressing the ON/OFF Switching Key and then using the Up and Down
7. Press the Set Key to display the next step.
8. The message “Do you want to adjust the next step?” will appear.
9. Press the Cam/Parameter Key.
Operation
+
+
Keys).
Select “Y” to return to 5 above. Select “N” to continue.
Select “Y” to return to 3 above. Select “N” to continue.
SET
SET
ON/
OFF
Display
(Display during normal RUN mode.)
Press the Set Key while pressing the Up or Down Keys.
The adjustment operation function will now be enabled.
The cam number will be displayed (flashing) in the Cam/Parameter
No. display.
Note Press any key other than the Up, Down, or Set Keys at this point to
Use the Up and Down Keys to set the cam number for which angle
data is to be adjusted.
Press the Set Key.
The angles for step 1 will be displayed (ON angle flashing and OFF
angle lit).
Press the Up and Down Keys to increase or decrease the ON angle.
The cam output ON angle will change at the same time.
Note The Up and Down Keys will not work if the ON section overlaps
Press the ON/OFF Switching Key to make the OFF angle flash. Use
the Up and Down Keys to increase and decrease the OFF angle. (The
cam output OFF angles will be changed at the same time.)
Note The Up and Down Keys will not work if the ON section overlaps
return to the previous status.
another step.
another step.
Explanation
Chapter 3
3-95