3F88L-CR002C Omron, 3F88L-CR002C Datasheet - Page 142

• Manufacturer Part Number: 3F88L-CR002C
• Description: CABLE RESOLVER FOR RS17/T 2M
• Manufacturer: Omron

Specifications of 3F88L-CR002C

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 3F88LCR002C

Operation
H Related Parameters (SET Mode)
D Baud Rate Setting
• The Baud rate setting function sets the baud rate for data transmission.
• The baud rate settings are explained below.
• Set the same baud rate for both the Master and Slave Units.
Note This parameter is enabled after the power has been turned OFF and then ON again.
Operation
• When the baud rate (Function No. b, Parameter No. 6) is displayed, the present baud rate settings
• Use the Up and Down Keys to change the data.
• Press the Set Key and the data will remain lit for approximately one second, the setting will be con-
• If the baud rate setting has been changed, turn OFF the power supply and turn it ON again.
D Data Transfer (Slave Unit Settings)
• Use this parameter to make the settings on the Slave Unit to enable data transfer.
D Data Transfer (Master Unit Settings)
• Use this parameter to make the settings on the Master Unit to enable data transfer.
• The settings are shown below.
3-90
Function
No.
Function
No.
Function
No.
flash in the SPEED/ON display.
firmed, and the display will resume flashing.
1: 9,600 bps (factory setting)
2: 19,200 bps
0: Disabled (factory setting)
1: Data read (Reads cam programs and parameters from the Slave to the Master Unit.)
2: Data write (Writes cam programs and parameters from the Master to the Slave Unit.)
3: Data verification (Verifies the Master programs and parameters against the Slave programs and
parameters.)
b (
t (
t (
t
t
b
)
)
)
Use the mode selection switch to change to SET mode.
Origin
compensation
value
Parameter
No.
Parameter
No.
Parameter
No.
6
0
1
Backlash compensation value
Setting range 1, 2
Setting range ---
Setting range 0 to 3
Function level
Function level
Baud rate
Function level
Chapter 3
1
1
2
2
2