HD6417144F50V Renesas Electronics America, HD6417144F50V Datasheet - Page 728

• Manufacturer Part Number: HD6417144F50V
• Description: IC SUPERH MCU ROMLESS 112QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7144r

Specifications of HD6417144F50V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Type: ROMless
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 112-QFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)EDK7145 - DEV EVALUATION KIT SH7145
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

19. Flash Memory (F-ZTAT Version)
and a transition can be made to verify mode. The error protection state can be cancelled by the
power-on reset only.
19.10
In PROM programmer mode, a PROM programmer can be used to perform programming/erasing
via a socket adapter, just as for a discrete flash memory. Use a PROM programmer that supports
the Renesas 256-kbyte flash memory on-chip MCU device type (FZTAT256V3A).
19.11
19.11.1 Module Standby Mode Setting
19.11.2 Notes when Converting the F-ZTAT Versions to the Masked-ROM Versions
Please note the following when converting the F-ZTAT versions to the masked-ROM versions,
with using the F-ZTAT application software.
In the masked-ROM version, addresses of the flash memory registers (refer to section 25.1,
Register Addresses Table (In the Order from Lower Addresses)) return undefined value if read.
When the F-ZTAT application software is used in the masked-ROM version, the FWP pin level
cannot be determined. When converting the program, make sure the reprogramming
(erasing/programming) part of the flash memory and the RAM emulation part not to be initiated.
In the masked-ROM version, boot mode pin setting should not be performed.
Note: This difference applies to all the F-ZTAT versions and all the masked-ROM versions that
Rev.4.00 Mar. 27, 2008 Page 682 of 882
REJ09B0108-0400
Access to flash memory can be enabled/disabled by the module standby control register
(MSTCR1). The initial value enables access to flash memory. Flash memory access is disabled
by setting the module standby control register. For details, see section 24, Power-Down
Modes.
have different ROM size.
PROM Programmer Mode
Usage Note