AT32UC3L-EK Atmel, AT32UC3L-EK Datasheet - Page 77

• Manufacturer Part Number: AT32UC3L-EK
• Description: KIT EVAL AVR32 UC3 MCU
• Manufacturer: Atmel
• Type: MCUr

Specifications of AT32UC3L-EK

• Contents: *
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: UC3L
• Kit Contents: Board
• Features: USB / Battery Powered, Board Controller / Bootloader
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Tool Type: Starter Kit
• Cpu Core: AVR 8
• Data Bus Width: 8 bit
• Processor Series: AT32
• Processor To Be Evaluated: AT32UC3L064
• Interface Type: USB, Capacitive Touch
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8. Flash Controller (FLASHCDW)
8.1
8.2
8.3
8.3.1
8.3.2
8.3.3
32099F–11/2010
Features
Overview
Product Dependencies
Power Management
Clocks
Interrupts
Rev: 1.0.2.0
•
•
•
•
•
•
•
•
•
•
•
•
•
The Flash Controller (FLASHCDW) interfaces the on-chip flash memory with the 32-bit internal
HSB bus. The controller manages the reading, writing, erasing, locking, and unlocking
sequences.
In order to use this module, other parts of the system must be configured correctly, as described
below.
If the CPU enters a sleep mode that disables clocks used by the FLASHCDW, the FLASHCDW
will stop functioning and resume operation after the system wakes up from sleep mode.
T h e F L A S H C D W h a s t w o b u s c l o c k s c o n n e c t e d : O n e H i g h S p e e d B u s c l o c k
(CLK_FLASHCDW_HSB) and one Peripheral Bus clock (CLK_FLASHCDW_PB). These clocks
are generated by the Power Manager. Both clocks are enabled at reset, and can be disabled by
writing to the Power Manager. The user has to ensure that CLK_FLASHCDW_HSB is not turned
off before reading the flash or writing the pagebuffer and that CLK_FLASHCDW_PB is not
turned off before accessing the FLASHCDW configuration and control registers. Failing to do so
may deadlock the bus.
The FLASHCDW interrupt request lines are connected to the interrupt controller. Using the
FLASHCDW interrupts requires the interrupt controller to be programmed first.
Controls on-chip flash memory
Supports 0 and 1 wait state bus access
Buffers reducing penalty of wait state in sequential code or loops
Allows interleaved burst reads for systems with one wait state, outputting one 32-bit word per
clock cycle for sequential reads
Secure State for supporting FlashVault
32-bit HSB interface for reads from flash and writes to page buffer
32-bit PB interface for issuing commands to and configuration of the controller
Flash memory is divided into 16 regions can be individually protected or unprotected
Additional protection of the Boot Loader pages
Supports reads and writes of general-purpose Non Volatile Memory (NVM) bits
Supports reads and writes of additional NVM pages
Supports device protection through a security bit
Dedicated command for chip-erase, first erasing all on-chip volatile memories before erasing
flash and clearing security bit
™
technology
AT32UC3L016/32/64
77