AT32UC3L-EK Atmel, AT32UC3L-EK Datasheet - Page 736

• Manufacturer Part Number: AT32UC3L-EK
• Description: KIT EVAL AVR32 UC3 MCU
• Manufacturer: Atmel
• Type: MCUr

Specifications of AT32UC3L-EK

• Contents: *
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: UC3L
• Kit Contents: Board
• Features: USB / Battery Powered, Board Controller / Bootloader
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Tool Type: Starter Kit
• Cpu Core: AVR 8
• Data Bus Width: 8 bit
• Processor Series: AT32
• Processor To Be Evaluated: AT32UC3L064
• Interface Type: USB, Capacitive Touch
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

31.3.7.1
31.3.7.2
31.3.8
32099F–11/2010
AUX-based Debug Features
Cyclic Redundancy Check (CRC)
NanoTrace
The MSU can be used to automatically calculate the CRC of a block of data in memory. The
MSU will then read out each word in the specified memory block and report the CRC32-value in
an MSU register.
The MSU additionally supports NanoTrace. This is a 32-bit AVR-specific feature, in which trace
data is output to memory instead of the AUX port. This allows the trace data to be extracted by
the debugger through the SAB, enabling trace features for aWire- or JTAG-based debuggers.
The user must write MSU registers to configure the address and size of the memory block to be
used for NanoTrace. The NanoTrace buffer can be anywhere in the physical address range,
including internal and external RAM, through an EBI, if present. This area may not be used by
the application running on the CPU.
Utilizing the Auxiliary (AUX) port gives access to a wide range of advanced debug features. Of
prime importance are the trace features, which allow an external debugger to receive continuous
information on the program execution in the CPU. Additionally, Event In and Event Out pins
allow external events to be correlated with the program flow.
Debug tools utilizing the AUX port should connect to the device through a Nexus-compliant Mic-
tor-38 connector, as described in the AVR32UC Technical Reference manual. This connector
includes the JTAG signals and the RESET_N pin, giving full access to the programming and
debug features in the device.
AT32UC3L016/32/64
736