HD6412320 RENESAS [Renesas Technology Corp], HD6412320 Datasheet - Page 914

• Manufacturer Part Number: HD6412320
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family H8S-2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 19 ROM
19.26
There are three kinds of flash memory program/erase protection: hardware protection, software
protection, and error protection.
19.26.1 Hardware Protection
Hardware protection refers to a state in which programming/erasing of flash memory is forcibly
disabled or aborted. Settings in flash memory control registers 1 and 2 (FLMCR1, FLMCR2) and
erase block registers 1 and 2 (EBR1, EBR2) are reset (see table 19.53).
Table 19.53 Hardware Protection
Item
FWE pin protection
Reset/standby
protection
19.26.2 Software Protection
Software protection can be implemented by setting the SWE1 bit in flash memory control register
1 (FLMCR1), SWE2 bit in FLMCR2 erase block registers 1 and 2 (EBR1, EBR2), and the RAMS
bit in the RAM emulation register (RAMER). When software protection is in effect, setting the P1
or E1 bit in FLMCR1, or the P2 or E2 bit in FLMCR2 does not cause a transition to program
mode or erase mode (see table 19.54).
Rev.6.00 Sep. 27, 2007 Page 884 of 1268
REJ09B0220-0600
Flash Memory Protection
Description
•
•
•
When a low level is input to the FWE pin,
FLMCR1, FLMCR2, EBR1, and EBR2 are
initialized and the program/erase protected
state is entered.
In a reset (including a WDT overflow reset)
and in standby mode, FLMCR1, FLMCR2,
EBR1, and EBR2 are initialized, and the
program/erase-protected state is entered.
In a reset via the RES pin, the reset state is
not entered unless the RES pin is held low
until oscillation stabilizes after powering on.
In the case of a reset during operation, hold
the RES pin low for the RES pulse width
specified in section 22.2.3, AC
Characteristics.
Program
Yes
Yes
Functions
Erase
Yes
Yes