HD6412320 RENESAS [Renesas Technology Corp], HD6412320 Datasheet - Page 356

• Manufacturer Part Number: HD6412320
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family H8S-2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 8 Data Transfer Controller
Source flag clearance
Clear
control
Clear
DTCER
Clear request
Select
On-chip
DTC
supporting
module
IRQ interrupt
Interrupt
request
Interrupt controller
CPU
DTVECR
Interrupt mask
Figure 8.3 Block Diagram of DTC Activation Source Control
When an interrupt has been designated a DTC activation source, existing CPU mask level and
interrupt controller priorities have no effect. If there is more than one activation source at the same
time, the DTC operates in accordance with the default priorities.
8.3.3
DTC Vector Table
Figure 8.4 shows the correspondence between DTC vector addresses and register information.
Table 8.5 shows the correspondence between activation, vector addresses, and DTCER bits. When
the DTC is activated by software, the vector address is obtained from: H'0400 + (DTVECR[6:0]
<< 1) (where << 1 indicates a 1-bit left shift). For example, if DTVECR is H'10, the vector
address is H'0420.
The DTC reads the start address of the register information from the vector address set for each
activation source, and then reads the register information from that start address. The register
information can be placed at predetermined addresses in the on-chip RAM. The start address of
the register information should be an integral multiple of four.
The configuration of the vector address is a 2-byte unit. These two bytes specify the lower bits of
the address in the on-chip RAM.
Rev.6.00 Sep. 27, 2007 Page 326 of 1268
REJ09B0220-0600