h8s-2169 Renesas Electronics Corporation., h8s-2169 Datasheet - Page 500

• Manufacturer Part Number: h8s-2169
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 15 Serial Communication Interface (SCI, IrDA)
Rev. 3.00 Jan 18, 2006 page 472 of 1044
REJ09B0280-0300
No
No
No
Figure 15.12 Sample Multiprocessor Serial Reception Flowchart
Read ORER and FER flags in SSR
Read ORER and FER flags in SSR
Read receive data in RDR
Read receive data in RDR
Clear RE bit in SCR to 0
Read RDRF flag in SSR
Read RDRF flag in SSR
Read MPIE bit in SCR
FER
FER
All data received?
This station's ID?
Start reception
Initialization
RDRF = 1?
RDRF = 1?
<End>
ORER = 1?
ORER = 1?
Yes
Yes
Yes
Yes
No
No
Yes
No
Yes
[4]
[3]
[1]
[2]
Error handling
(Continued on
next page)
[5]
[1]
[2]
[3]
[4]
[5]
SCI initialization:
The RxD pin is automatically
designated as the receive data
input pin.
ID reception cycle:
Set the MPIE bit in SCR to 1.
SCI status check, ID reception
and comparison:
Read SSR and check that the
RDRF flag is set to 1, then read
the receive data in RDR and
compare it with this station’s ID.
If the data is not this station’s ID,
set the MPIE bit to 1 again, and
clear the RDRF flag to 0.
If the data is this station’s ID,
clear the RDRF flag to 0.
SCI status check and data
reception:
Read SSR and check that the
RDRF flag is set to 1, then read
the data in RDR.
Receive error handling and break
detection:
If a receive error occurs, read the
ORER and FER flags in SSR to
identify the error. After
performing the appropriate error
handling, ensure that the ORER
and FER flags are both cleared
to 0.
Reception cannot be resumed if
either of these flags is set to 1.
In the case of a framing error, a
break can be detected by reading
the RxD pin value.