attiny167-esxz ATMEL Corporation, attiny167-esxz Datasheet - Page 175

• Manufacturer Part Number: attiny167-esxz
• Description: 8-bit Avr 8-bit Microcontroller Microcontroller With 16k Bytes In-system Programmable Flash And Lin Controller
• Manufacturer: ATMEL Corporation

15.6.3
7728A–AUTO–07/08
LIN Enable Interrupt Register - LINENIR
• Bit 2 - LIDOK: Identifier Interrupt
• Bit 1 - LTXOK: Transmit Performed Interrupt
• Bit 0 - LRXOK: Receive Performed Interrupt
• Bits 7:4 - Reserved Bits
• Bit 3 - LENERR: Enable Error Interrupt
• Bit 2 - LENIDOK: Enable Identifier Interrupt
Initial Value
Read/Write
–
–
resets all LINERR bits.
–
–
–
–
–
–
written to zero when LINENIR is written.
–
–
–
–
Bit
The user clears this bit by writing 1 in order to reset this interrupt. Resetting LERR also
In UART mode, this bit is also cleared by reading LINDAT.
This bit generates an interrupt if its respective enable bit - LENIDOK - is set in LINENIR.
The user clears this bit by writing 1, in order to reset this interrupt.
This bit generates an interrupt if its respective enable bit - LENTXOK - is set in LINENIR.
The user clears this bit by writing 1, in order to reset this interrupt.
In UART mode, this bit is also cleared by writing LINDAT.
This bit generates an interrupt if its respective enable bit - LENRXOK - is set in LINENIR.
The user clears this bit by writing 1, in order to reset this interrupt.
In UART mode, this bit is also cleared by reading LINDAT.
These bits are reserved for future use. For compatibility with future devices, they must be
0 = No error,
1 = An error has occurred.
0 = No identifier,
1 = Slave task: Identifier present, master task: Tx Header complete.
0 = No Tx,
1 = Tx Response complete.
0 = No Rx
1 = Rx Response complete.
0 = Error interrupt masked,
1 = Error interrupt enabled.
0 = Identifier interrupt masked,
1 = Identifier interrupt enabled.
R
7
0
-
R
6
0
-
R
5
0
-
R
4
0
-
LENERR
R/W
3
0
LENIDOK
R/W
2
0
LENTXOK
R/W
1
0
ATtiny167
LENRXOK
R/W
0
0
LINENIR
175