attiny167-esxz ATMEL Corporation, attiny167-esxz Datasheet - Page 136

• Manufacturer Part Number: attiny167-esxz
• Description: 8-bit Avr 8-bit Microcontroller Microcontroller With 16k Bytes In-system Programmable Flash And Lin Controller
• Manufacturer: ATMEL Corporation

136
ATtiny167
The following code examples show how to initialize the SPI as a Master and how to perform a
simple transmission.
DDR_SPI in the examples must be replaced by the actual Data Direction Register controlling the
SPI pins. DD_MOSI, DD_MISO and DD_SCK must be replaced by the actual data direction bits
for these pins. E.g. if MOSI is placed on pin PB2, replace DD_MOSI with DDB2 and DDR_SPI
with DDRB.
Note:
Assembly Code Example
C Code Example
SPI_MasterInit:
SPI_MasterTransmit:
Wait_Transmit:
void SPI_MasterInit(void)
{
}
void SPI_MasterTransmit(char cData)
{
}
; Set MOSI and SCK output, all others input
ldi
out
; Enable SPI, Master, set clock rate fck/16
ldi
out
ret
; Start transmission of data (r16)
out
; Wait for transmission complete
in
sbrs
rjmp
ret
/* Set MOSI and SCK output, all others input */
DDR_SPI = (1<<DD_MOSI)|(1<<DD_SCK);
/* Enable SPI, Master, set clock rate fck/16 */
SPCR = (1<<SPE)|(1<<MSTR)|(1<<SPR0);
/* Start transmission */
SPDR = cData;
/* Wait for transmission complete */
while(!(SPSR & (1<<SPIF)));
1. The example code assumes that the part specific header file is included.
r17,(1<<DD_MOSI)|(1<<DD_SCK)
DDR_SPI,r17
r17,(1<<SPE)|(1<<MSTR)|(1<<SPR0)
SPCR,r17
SPDR,r16
r17,SPSR
r17,SPIF
Wait_Transmit
(1)
(1)
7728A–AUTO–07/08