attiny167-esxz ATMEL Corporation, attiny167-esxz Datasheet - Page 10

• Manufacturer Part Number: attiny167-esxz
• Description: 8-bit Avr 8-bit Microcontroller Microcontroller With 16k Bytes In-system Programmable Flash And Lin Controller
• Manufacturer: ATMEL Corporation

2.5
2.5.1
10
Stack Pointer
ATtiny167
SPH and SPL – Stack Pointer Register
Figure 2-3.
In the different addressing modes these address registers have functions as fixed displacement,
automatic increment, and automatic decrement (see the instruction set reference for details).
The Stack is mainly used for storing temporary data, for storing local variables and for storing
return addresses after interrupts and subroutine calls. The Stack Pointer Register always points
to the top of the Stack. Note that the Stack is implemented as growing from higher memory loca-
tions to lower memory locations. This implies that a Stack PUSH command decreases the Stack
Pointer.
The Stack Pointer points to the data SRAM Stack area where the Subroutine and Interrupt
Stacks are located. This Stack space in the data SRAM must be defined by the program before
any subroutine calls are executed or interrupts are enabled. The Stack Pointer must be set to
point above 0x60. The Stack Pointer is decremented by one when data is pushed onto the Stack
with the PUSH instruction, and it is decremented by two when the return address is pushed onto
the Stack with subroutine call or interrupt. The Stack Pointer is incremented by one when data is
popped from the Stack with the POP instruction, and it is incremented by two when data is
popped from the Stack with return from subroutine RET or return from interrupt RETI.
The AVR Stack Pointer is implemented as two 8-bit registers in the I/O space. The number of
bits actually used is implementation dependent. Note that the data space in some implementa-
tions of the AVR architecture is so small that only SPL is needed. In this case, the SPH Register
will not be present
X-register
Y-register
Z-register
Bit
Read/Write
Initial Value
RAMEND
RAMEND
SP15
The X-, Y-, and Z-registers
R/W
R/W
SP7
15
7
15
7
R27 (0x1B)
15
7
R29 (0x1D)
15
7
R31 (0x1F)
RAMEND
RAMEND
SP14
SP6
R/W
R/W
14
6
RAMEND
RAMEND
SP13
R/W
SP5
R/W
13
5
XH
YH
ZH
0
RAMEND
RAMEND
SP12
R/W
R/W
SP4
12
4
RAMEND
RAMEND
SP11
SP3
R/W
R/W
11
3
0
0
7
R26 (0x1A)
7
R28 (0x1C)
7
R30 (0x1E)
RAMEND
RAMEND
SP10
SP2
R/W
R/W
10
2
RAMEND
RAMEND
R/W
R/W
SP9
SP1
9
1
XL
YL
ZL
RAMEND
RAMEND
7728A–AUTO–07/08
SP8
SP0
R/W
R/W
8
0
SPH
SPL
0
0
0
0
0
0