AT90PWM81 Atmel Corporation, AT90PWM81 Datasheet - Page 169

• Manufacturer Part Number: AT90PWM81
• Manufacturer: Atmel Corporation

Specifications of AT90PWM81

• Flash (kbytes): 8 Kbytes
• Pin Count: 20
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 20
• Ext Interrupts: 3
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 10
• Adc Speed (ksps): 125
• Analog Comparators: 3
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 0.25
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 125
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 1
• Output Compare Channels: 8
• Input Capture Channels: 1
• Pwm Channels: 6
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

13.18.1
13.18.2
13.18.3
13.19 Analog Synchronization
7734P–AVR–08/10
Available Input Mode according to Running Mode
Event Capture
Using the Input Capture Unit
Some Input Modes are not consistent with some Running Modes. So the table below gives the input
modes which are valid according to running modes.
Table 13-6.
The PSCR can capture the value of time (PSCR counter) when a retrigger event or fault event occurs on
PSCR inputs. This value can be read by software in PICRrH/L register.
The main challenge when using the Input Capture unit is to assign enough processor capacity for handling
the incoming events. The time between two events is critical. If the processor has not read the captured
value in the PICR1 Register before the next event occurs, the PICR1 will be overwritten with a new value.
In this case the result of the capture will be incorrect.
When using the Input Capture interrupt, the PICR1 Register should be read as early in the interrupt han-
dler routine as possible. Even though the Input Capture interrupt has relatively high priority, the maximum
interrupt response time is dependent on the maximum number of clock cycles it takes to handle any of the
other interrupt requests.
PSCR generates a signal to synchronize the sample and hold; synchronization is mandatory for
measurements.
Input Mode Number :
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Available Input Modes according to Running Modes
1 Ramp Mode
Valid
Do not use
Do not use
Valid
Do not use
Do not use
Valid
Valid
Valid
Do not use
Valid
Do not use
2 Ramp Mode
Valid
Valid
Valid
Valid
Valid
Valid
Valid
Valid
Valid
Valid
AT90PWM81
4 Ramp Mode
Valid
Valid
Valid
Valid
Valid
Valid
Valid
Valid
Valid
Valid
169