EP1C3 ALTERA [Altera Corporation], EP1C3 Datasheet - Page 41

• Manufacturer Part Number: EP1C3
• Description: Cyclone FPGA Family
• Manufacturer: ALTERA [Altera Corporation]

Preliminary Information
Altera Corporation
Each PLL has one pre-scale divider, n, that can range in value from 1 to 32.
Each PLL also has one multiply divider, m, that can range in value from 2
to 32. Global clock outputs have two post scale G dividers for global clock
outputs, and external clock outputs have an E divider for external clock
output, both ranging from 1 to 32. The Quartus II software automatically
chooses the appropriate scaling factors according to the input frequency,
multiplication, and division values entered.
External Clock Inputs
Each PLL supports single-ended or differential inputs for source-
synchronous receivers or for general-purpose use. The dedicated clock
pins (CLK[3..0]) feed the PLL inputs. These dual-purpose pins can also
act as LVDS input pins. See
Table 11
pins.
For more information on LVDS I/O support, see
page
External Clock Outputs
Each PLL supports one differential or one single-ended output for source-
synchronous transmitters or for general-purpose external clocks. If the
PLL does not use these PLL_OUT pins, the pins are available for use as
general-purpose I/O pins. The PLL_OUT pins support all I/O standards
shown in
3.3-V LVTTL/LVCMOS
2.5-V LVTTL/LVCMOS
1.8-V LVTTL/LVCMOS
1.5-V LVCMOS
3.3-V PCI
LVDS
SSTL-2 class I
SSTL-2 class II
SSTL-3 class I
SSTL-3 class II
Differential SSTL-2
Table 11. PLL I/O Standards
59.
I/O Standard
shows the I/O standards supported by PLL input and output
Table
11.
Figure
25.
CLK Input
v
v
v
v
v
v
v
v
v
v
Cyclone FPGA Family Data Sheet
“LVDS I/O Pins” on
EXTCLK Output
v
v
v
v
v
v
v
v
v
v
v
41