peb20560 Infineon Technologies Corporation, peb20560 Datasheet - Page 64

• Manufacturer Part Number: peb20560
• Description: Dsp Oriented Pbx Controller Doc
• Manufacturer: Infineon Technologies Corporation

Semiconductor Group
The address is defined by the value stored in XAD1 (1-byte address) or XAD1 and XAD2
(2-byte address). The control byte is fixed to 10
According to the PBC conventions, the control response byte has the following structure:
bit7…6 :
bit5
bit4
bit3…2 :
bit1
bit0
I-Frame with Data
The address is defined by the value stored in XAD1 (1-byte address) or XAD1 and XAD2
(2-byte address). The control byte is fixed to 10
contains the XFIFO contents.
Note: The control response byte has to be generated by software.
Data Transfer
Polling of Direct Data
When direct data was loaded (XDD executed) an I-frame is generated as a response to
a RR-poll.
After checking STAR:XFW, blocks of up to 32 bytes may be entered in XFIFO. When
more than 32 bytes are to be transmitted the XPR-interrupt is used to indicate that the
CPU accessible XFIFO-part is free again. A maximum of 64 bytes may be stored before
the actual transmission is started.
A RR-acknowledge (poll bit = 0) causes an ISTA:XPR interrupt, XFIFO is cleared and
STAR:XFW is set.
When the SACCO receives a RR-poll frame and no data was loaded in XFIFO it
generates automatically a RR-response.
bit 7
flag
1
:
:
:
:
10
1
AREP : 1/0: autorepeating is enabled/disabled
00
DOV : inverted status of the bit RSTA:RDO (RFIFO overflow)
1
address
0
: response to an I-frame, no further data follows
: µP connected (PBC operates optionally in stand alone mode)
: SACCO FIFO available for data reception
: fixed value, no functionality.
(Read back value of CMDR:AREP)
control byte
1
AREP
2-18
data
H
0
H
.
(I-frame, final bit = 1). The data field
Functional Block Description
CRC-word
0
DOV
PEB 20560
bit 0
flag
2003-08
1