S1D13505 Epson Electronics America, Inc., S1D13505 Datasheet - Page 297

no-image

S1D13505

Manufacturer Part Number
S1D13505
Description
LCD Controller
Manufacturer
Epson Electronics America, Inc.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
S1D13505F00A
Manufacturer:
EPSON
Quantity:
254
Part Number:
S1D13505F00A100
Manufacturer:
EPSON
Quantity:
8 000
Part Number:
S1D13505F00A2
Manufacturer:
EPSON
Quantity:
5
Part Number:
S1D13505F00A2
Manufacturer:
EPSON/爱普生
Quantity:
20 000
Part Number:
S1D13505F00A200
Manufacturer:
EPSON
Quantity:
1 400
Part Number:
S1D13505F00A200
Manufacturer:
Epson Electronics America Inc-Semiconductor Div
Quantity:
10 000
Part Number:
S1D13505F00A200
Manufacturer:
EPSON/爱普生
Quantity:
20 000
Epson Research and Development
Vancouver Design Center
Program Messages
13505SHOW Demonstration Program
Issue Date: 01/02/02
ERROR: Could not initialize device.
These messages generally mean that the given hardware/software setup violates the timing limita-
tions described in the 13505 Hardware Functional Specification, document number X23A-A-001-
xx.
ERROR: Unknown command line argument.
An invalid command line argument was entered. Refer to the help screen or documentation for valid
command line arguments.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL currently supports only one
device.
ERROR: Could not register S1D13505 device.
A 13505 device was not found at the configured addresses. Check the configuration address using
the 13505CFG configuration program.
ERROR: Did not find a 13505 device.
The HAL was unable to read the revision code register on the S1D13505. Ensure that the S1D13505
hardware is installed and that the hardware platform has been set up correctly.
ERROR: Continual screen read will not work with the /a switch.
The continual screen read function reads one screen indefinitely, so it is not possible to automatically
cycle through the video modes.
WARNING: b= option used with /noinit, so bit-per-pixel and display
memory will NOT be changed.
The b= option requests that registers be changed for a given bit-per-pixel mode, while the /noinit
option requests the opposite. To resolve this contradiction 13505SHOW will not change either the
registers or the display memory. Consequently “13505SHOW b=?? /noinit” is only useful for
continually reading the display memory.
UNSUPPORTED MODE: Cannot show ?? bpp in portrait mode.
Only 8, 15, 16 bit-per-pixel modes are supported in portrait mode.
ERROR: Could not change to ?? bit-per-pixel.
The HAL library detected that the requested bit-per-pixel mode will violate the hardware specifica-
tions for clocks. To reprogram the clocks, run 13505CFG and select the desired bit-per-pixel mode.
X23A-B-002-05
S1D13505
Page 7

Related parts for S1D13505