LAN9311-NZW Standard Microsystem (Smsc), LAN9311-NZW Datasheet - Page 335

• Manufacturer Part Number: LAN9311-NZW
• Description: Ethernet Switch 2-Port 10Mbps/100Mbps 128-Pin XVTQFP
• Manufacturer: Standard Microsystem (Smsc)

Specifications of LAN9311-NZW

• Package: 128XVTQFP
• Phy/transceiver Interface: MII
• Number Of Primary Switch Ports: 2
• Maximum Data Rate: 100 Mbps
• Internal Memory Buffer Size: 32 KB
• Vlan Support: Yes
• Power Supply Type: Analog
• Minimum Single Supply Voltage: 3 V
• Maximum Single Supply Voltage: 3.6 V
• Maximum Supply Current: 0.295 A
• Maximum Power Dissipation: 1070 mW

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i
14.5.2.12
BITS
31:0
RX CRC
Count of packets that have between 64 and the maximum allowable number
of bytes and have a bad FCS, but do not have an extra nibble. The max
number of bytes is 1518 for untagged packets and 1522 for tagged packets.
If Jumbo2K (bit 3) is set in the
(MAC_RX_CFG_x), the max number of bytes is 2048.
Note:
Port x MAC Receive CRC Error Count Register (MAC_RX_CRCERR_CNT_x)
This register provides a counter of received packets that with CRC errors. The counter is cleared upon
being read.
This counter will stop at its maximum value of FFFF_FFFFh.
Minimum rollover time at 100Mbps is approximately 137 hours.
Register #:
Port0: 0419h
Port1: 0819h
Port2: 0C19h
DESCRIPTION
Port x MAC Receive Configuration Register
DATASHEET
335
Size:
32 bits
TYPE
RC
Revision 1.7 (06-29-10)
00000000h
DEFAULT