LAN9311-NZW Standard Microsystem (Smsc), LAN9311-NZW Datasheet - Page 219

• Manufacturer Part Number: LAN9311-NZW
• Description: Ethernet Switch 2-Port 10Mbps/100Mbps 128-Pin XVTQFP
• Manufacturer: Standard Microsystem (Smsc)

Specifications of LAN9311-NZW

• Package: 128XVTQFP
• Phy/transceiver Interface: MII
• Number Of Primary Switch Ports: 2
• Maximum Data Rate: 100 Mbps
• Internal Memory Buffer Size: 32 KB
• Vlan Support: Yes
• Power Supply Type: Analog
• Minimum Single Supply Voltage: 3 V
• Maximum Single Supply Voltage: 3.6 V
• Maximum Supply Current: 0.295 A
• Maximum Power Dissipation: 1070 mW

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i
14.2.5.18
BITS
31:0
Clock Target Reload High (CLOCK_TARGET_RELOAD_HI)
This field contains the high 32-bits of the 64-bit 1588 Clock Target Reload
value that is reloaded to the 1588 Clock Compare value.
1588 Clock Target Reload High-DWORD Register (1588_CLOCK_TARGET_RELOAD_HI)
This read/write register combined with
(1588_CLOCK_TARGET_RELOAD_LO)
Clock Target Reload is the value that is reloaded to the 1588 Clock Compare value when a clock
compare event occurs and the
(1588_CONFIG)
additional information.
Note: Both this register and the
(1588_CLOCK_TARGET_RELOAD_LO)
Offset:
is set. Refer to
184h
DESCRIPTION
Reload/Add (RELOAD_ADD)
Chapter 11, "IEEE 1588 Hardware Time Stamp Unit," on page 155
DATASHEET
1588 Clock Target Reload/Add Low-DWORD Register
form the 64-bit 1588 Clock Target Reload value. The 1588
219
1588 Clock Target Reload/Add Low-DWORD Register
Size:
must be written for either to be affected.
bit of the
32 bits
1588 Configuration Register
TYPE
R/W
Revision 1.7 (06-29-10)
00000000h
DEFAULT
for