LAN9311-NZW Standard Microsystem (Smsc), LAN9311-NZW Datasheet - Page 196
LAN9311-NZW
Manufacturer Part Number
LAN9311-NZW
Description
Ethernet Switch 2-Port 10Mbps/100Mbps 128-Pin XVTQFP
Manufacturer
Standard Microsystem (Smsc)
Datasheet
1.LAN9311-NU.pdf
(460 pages)
Specifications of LAN9311-NZW
Package
128XVTQFP
Phy/transceiver Interface
MII
Number Of Primary Switch Ports
2
Maximum Data Rate
100 Mbps
Internal Memory Buffer Size
32 KB
Vlan Support
Yes
Power Supply Type
Analog
Minimum Single Supply Voltage
3 V
Maximum Single Supply Voltage
3.6 V
Maximum Supply Current
0.295 A
Maximum Power Dissipation
1070 mW
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LAN9311-NZW
Manufacturer:
Standard
Quantity:
2
Company:
Part Number:
LAN9311-NZW
Manufacturer:
Microchip Technology
Quantity:
10 000
- Current page: 196 of 460
- Download datasheet (5Mb)
Revision 1.7 (06-29-10)
14.2.3.3
31:28
27:16
15:12
BITS
11:0
RESERVED
GPIO Interrupt Enable[11:0] (GPIO[11:0]_INT_EN)
When set, these bits enable the corresponding GPIO interrupt.
Note:
RESERVED
GPIO Interrupt[11:0] (GPIO[11:0]_INT)
These signals reflect the interrupt status as generated by the GPIOs. These
interrupts are configured through the
Register
Note:
General Purpose I/O Interrupt Status and Enable Register (GPIO_INT_STS_EN)
This read/write register contains the GPIO interrupt status bits.
Writing a 1 to any of the interrupt status bits acknowledges and clears the interrupt. If enabled, these
interrupt bits are cascaded into bit 12 (GPIO) of the
to any of the interrupt enable bits will enable the corresponding interrupt as a source. Status bits will
still reflect the status of the interrupt source regardless of whether the source is enabled as an interrupt
in this register. Bit 12 (GPIO_EN) of the
for an actual system level interrupt to occur. Refer to
additional information.
The GPIO interrupts must also be enabled via bit 12 (GPIO_EN) of
the
interrupt pin (IRQ) to be asserted.
(GPIO_CFG).
As GPIO interrupts, GPIO inputs are level sensitive and must be
active greater than 40 nS to be recognized as interrupt inputs.
Offset:
Interrupt Enable Register (INT_EN)
1E8h
DESCRIPTION
General Purpose I/O Configuration
DATASHEET
Interrupt Enable Register (INT_EN)
196
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
in order to cause the
Size:
Interrupt Status Register
Chapter 5, "System Interrupts," on page 49
32 bits
must also be set in order
TYPE
R/WC
R/W
SMSC LAN9311/LAN9311i
RO
RO
(INT_STS). Writing a 1
DEFAULT
Datasheet
0h
0h
-
-
for
Related parts for LAN9311-NZW
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Ethernet Switch 3-Port 10Mbps/100Mbps 56-Pin QFN EP
Manufacturer:
Standard Microsystem (Smsc)
Datasheet:
Part Number:
Description:
Manufacturer:
Standard Microsystem (Smsc)
Datasheet: