LAN9311-NZW Standard Microsystem (Smsc), LAN9311-NZW Datasheet - Page 174

• Manufacturer Part Number: LAN9311-NZW
• Description: Ethernet Switch 2-Port 10Mbps/100Mbps 128-Pin XVTQFP
• Manufacturer: Standard Microsystem (Smsc)

Specifications of LAN9311-NZW

• Package: 128XVTQFP
• Phy/transceiver Interface: MII
• Number Of Primary Switch Ports: 2
• Maximum Data Rate: 100 Mbps
• Internal Memory Buffer Size: 32 KB
• Vlan Support: Yes
• Power Supply Type: Analog
• Minimum Single Supply Voltage: 3 V
• Maximum Single Supply Voltage: 3.6 V
• Maximum Supply Current: 0.295 A
• Maximum Power Dissipation: 1070 mW

Revision 1.7 (06-29-10)
BITS
3:1
4
0
IRQ Polarity (IRQ_POL)
When cleared, this bit enables the IRQ line to function as an active low
output. When set, the IRQ output is active high. When the IRQ is configured
as an open-drain output (via the IRQ_TYPE bit), this bit is ignored, and the
interrupt is always active low.
0: IRQ active low output
1: IRQ active high output
RESERVED
IRQ Buffer Type (IRQ_TYPE)
When this bit is cleared, the IRQ pin functions as an open-drain output for
use in a wired-or interrupt configuration. When set, the IRQ is a push-pull
driver.
Note:
0: IRQ pin open-drain output
1: IRQ pin push-pull driver
Note 14.1 Register bits designated as NASR are not reset when either the SRST bit in the
When configured as an open-drain output, the IRQ_POL bit is
ignored and the interrupt output is always active low.
Configuration Register (HW_CFG)
Register (RESET_CTL)
DESCRIPTION
DATASHEET
is set.
174
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
register or the DIGITAL_RST bit in the
Note 14.1
Note 14.1
NASR
NASR
TYPE
R/W
R/W
SMSC LAN9311/LAN9311i
RO
Reset Control
DEFAULT
Hardware
Datasheet
0b
0b
-