DS3184DK Maxim Integrated Products, DS3184DK Datasheet - Page 373

• Manufacturer Part Number: DS3184DK
• Description: KIT DEMO FOR DS3184
• Manufacturer: Maxim Integrated Products

Specifications of DS3184DK

• Main Purpose: Telecom, ATM / Packet PHYs
• Utilized Ic / Part: DS3184
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

13.2 JTAG TAP Controller State Machine Description
This section covers the details on the operation of the Test Access Port (TAP) Controller State Machine. See
Figure 13-2
responds to the logic level at JTMS on the rising edge of JTCLK.
Figure 13-2. JTAG TAP Controller State Machine
Test-Logic-Reset. When JTRST is changed from low to high, the TAP controller starts in the Test-Logic-Reset
state, and the Instruction Register is loaded with the IDCODE instruction. All system logic and I/O pads on the
device operate normally. This state can also be reached from any other state by holding JTMS high and clocking
JTCLK five times.
Run-Test-Idle. Run-Test-Idle is used between scan operations or during specific tests. The Instruction Register
and Test Register remain idle.
Select-DR-Scan. All test registers retain their previous state. With JTMS low, a rising edge of JTCLK moves the
controller into the Capture-DR state and initiates a scan sequence. JTMS high moves the controller to the Select-
IR-Scan state.
Capture-DR. Data may be parallel loaded into the Test Data register selected by the current instruction. If the
instruction does not call for a parallel load or the selected register does not allow parallel loads, the Test Register
remains at its current value. On the rising edge of JTCLK, the controller goes to the Shift-DR state if JTMS is low or
to the Exit1-DR state if JTMS is high.
for details on each of the states described below. The TAP controller is a finite state machine that
1
0
Test-Logic-Reset
Run-Test/Idle
0
1
1
0
Capture-DR
1
Select
DR-Scan
Shift-DR
Pause-DR
Update-DR
Exit1- DR
Exit2-DR
373
0
0
1
0
1
1
0
1
0
1
0
1
0
Capture-IR
1
Select
IR-Scan
Shift-IR
Exit1-IR
Pause-IR
Exit2-IR
Update-IR
0
0
1
0
1
1
0
1
0
1
0