PIC18C242 MICROCHIP [Microchip Technology], PIC18C242 Datasheet - Page 115

• Manufacturer Part Number: PIC18C242
• Description: High-Performance Microcontrollers with 10-Bit A/D
• Manufacturer: MICROCHIP [Microchip Technology]

13.5.1
The PWM period is specified by writing to the PR2 reg-
ister. The PWM period can be calculated using the fol-
lowing formula:
PWM frequency is defined as 1 / [PWM period].
When TMR2 is equal to PR2, the following three events
occur on the next increment cycle:
• TMR2 is cleared
• The CCP1 pin is set (exception: if PWM duty
• The PWM duty cycle is latched from CCPR1L into
cycle = 0%, the CCP1 pin will not be set)
CCPR1H
Note:
7/99 Microchip Technology Inc.
PWM period = (PR2) + 1] • 4 • T
PWM PERIOD
The Timer2 postscaler (see Section 10.0)
is not used in the determination of the
PWM frequency. The postscaler could be
used to have a servo update rate at a dif-
ferent frequency than the PWM output.
(TMR2 prescale value)
OSC
•
Preliminary
13.5.2
The PWM duty cycle is specified by writing to the
CCPR1L register and to the CCP1CON<5:4> bits. Up
to 10-bit resolution is available. The CCPR1L contains
the eight MSbs and the CCP1CON<5:4> contains the
two LSbs. This 10-bit value is represented by
CCPR1L:CCP1CON<5:4>. The following equation is
used to calculate the PWM duty cycle in time:
CCPR1L and CCP1CON<5:4> can be written to at any
time, but the duty cycle value is not latched into
CCPR1H until after a match between PR2 and TMR2
occurs (i.e., the period is complete). In PWM mode,
CCPR1H is a read-only register.
The CCPR1H register and a 2-bit internal latch are
used to double buffer the PWM duty cycle. This double
buffering is essential for glitchless PWM operation.
When the CCPR1H and 2-bit latch match TMR2 con-
catenated with an internal 2-bit Q clock or 2 bits of the
TMR2 prescaler, the CCP1 pin is cleared.
Maximum PWM resolution (bits) for a given PWM fre-
quency:
Note:
PWM duty cycle = (CCPR1L:CCP1CON<5:4>) •
PWM DUTY CYCLE
If the PWM duty cycle value is longer than
the PWM period, the CCP1 pin will not be
cleared.
=
log
----------------------------- bits
log
T
PIC18CXX2
OSC
---------------
F
F
PWM
OSC
2
• (TMR2 prescale value)
DS39026B-page 115