MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 59

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Operating the Unit—MPCBL0050
4.0
4.1
4.2
4.2.1
Note:
4.2.2
Warning:
September 2007
Order Number: 318146-001
Operating the Unit
Board Configuration DIP Switches
The MPCBL0050 provides several DIP switches that allow the user to configure certain
options not configurable through the EFI BIOS setup utility. The MPCBL0050 is shipped
pre-configured and jumper positions do not generally need to be altered. For detailed
information on DIP switch configuration, see
Installing and Extracting the SBC
The MPCBL0050 SBC has two ejector handles to help insert the board into and eject the
board from the chassis.
Insertion
To insert the board into the chassis, open the ejector handles and push the board into
the chassis. Once the ejector handles slide into the top and bottom notches in the
chassis, push both ejector handles toward the faceplate of the board until the handles
click into place. The ejector handles provide a positive cam action, which ensures that
the blade is properly seated. Once the bottom ejector handle is closed, the Hot Swap
switch is engaged and this starts the normal power-on sequence.
Make sure that the plastic slider on the bottom ejector handle is in the low position
after inserting the SBC. You can do that by pressing the slider down after board is fully
inserted. This will assure proper enabling of hot swap microswitch, and board will start
booting.
Ejection
To eject the board from the chassis, slide the bottom ejector handle mechanism so it
releases from the faceplate and then gently pull the bottom ejector handle away from
the faceplate. When the lower ejector handle is disengaged from the faceplate, the Hot
Swap switch is released and this starts the normal board shutdown process. This power
down process is identified by the blinking blue Hot Swap LED. Once the Hot Swap LED
turns solid blue, slide the top ejector handle mechanism so it releases from the
faceplate and use both ejector handles to disengage the board from the backplane.
See
Swap LED.
Removing the SBC before the Hot Swap LED is solid blue can lead to device corruption
or failure.
Section 5.10
for detailed information on the function and operation of the Hot
Intel NetStructure
Section
3.4.
®
MPCBL0050 Single Board Computer
Technical Product Specification
59