MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 172

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Figure 40.
9.8.1.3
Intel NetStructure
Technical Product Specification
172
®
Configuration for RHEL
sbcutils RPM Installation
The sbcutils RPM is installed via the following procedure. For complete details on
sbcutils installation, refer to the sbcutilities RPM install procedure on the MPCBL0050
product page at http://www.intel.com.
3. Ensure that at least one
4. Reboot the blade.
5. Change HyperTerminal to 9600, 8, n, 1, n to make sure the EFI BIOS, bootloader
6. Optionally, if needed, configure the host OS IP address. This IP address can be the
1. Copy the RPM to the target blade. Ensure that the RPM copied is for the particular
2. Check the version of
3. If a previous version of the
4. Install a new version of
MPCBL0050 Single Board Computer
modify the /etc/inittab file. Issue the
the system console by adding or modifying the “co” service as follows:
a. For MontaVista:
b. For Red Hat RHEL:
and OS come up at 9600 baud.
same or different as the IP address that will be assigned to the IPMC controller on
the blade. The IP address of the host OS and IPMC should be on the same subnet.
For the MPCBL0050 blade, use Eth4 for base interface port A.
OS installed on the target blade.
command:
— For MontaVista:
— For Red Hat RHEL:
co:2345:respawn:/sbin/agetty ttyS0 CON9600 vt102
co:2345:respawn:/sbin/agetty ttyS0 9600 vt100-nav
# vi /etc/network/interfaces
# vi /etc/sysconfig/network-scripts/ifcfg-eth
rpm -e sbcutils
Add screen shot
sbcutils
sbcutils
agetty
sbcutils
installed:
process is running on the serial port. To do this,
as follows:
vi /etc/inittab
RPM is installed, remove it by using this
rpm -q sbcutils
MPCBL0050—Serial Over LAN
command and change
Order Number: 318146-001
September 2007