MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 29

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Feature Overview—MPCBL0050
Table 5.
Note:
Caution:
Caution:
2.2.7
2.2.7.1
September 2007
Order Number: 318146-001
AdvancedMC connections (Sheet 2 of 2)
Although the AdvancedMC connector provides access to an SAS port, Intel has not
validated AdvancedMC cards supporting an SAS HDD. Due to thermal constraints, using
such a card may not be possible in certain environments.
Never ship the MPCBL0050 SBC with any AdvancedMC modules installed.
Shipping the MPCBL0050 SBC with an AdvancedMC module installed may cause
damage to the SBC or AdvancedMCs. Damage that occurs to the MPCBL0050 due to an
AdvancedMC module installed during shipment will not be covered by the MPCBL0050
product warranty.
Always operate the MPCBL0050 SBC with the AdvancedMC filler panel or AdvancedMC
module installed.
The AdvancedMC module slot should not be left open or uncovered when the
MPCBL0050 SBC is in use. The MPCBL0050 SBC includes one AdvancedMC filler panel,
which is provided to optimize cooling and radiated emissions for the SBC.
Firmware Hub for EFI BIOS
The MPCBL0050 SBC has two physically separate 1 MByte EFI (Extensible Firmware
interface) flash devices:
The flash is allocated for storing the binary code of the EFI.
The SBC boots from the primary flash FWH0 under normal circumstances. If booting
EFI from primary flash FWH0 fails, a hardware mechanism automatically changes the
flash device select logic to boot from the recovery flash FWH1.
For instructions on how to update the EFI BIOS, refer to
the EFI update, the user must reset the system for the new EFI BIOS image to take
effect.
FWH 0 (Main EFI)
BIOS executes code off of the flash device and performs checksum validation of its
operational code. This checksum occurs in the boot block of BIOS. When the user
performs a BIOS update, the BIOS image is stored in FWH0 only. FWH0 also stores the
factory default and user-configured BIOS options (CMOS settings).
• Primary EFI BIOS flash (FWH0)
• Recovery EFI BIOS flash (FWH1)
Link #
12
13
14
15
16
17
18
19
20
Function
Not Connected
To/From Rear Transition Module (RTM) Connector J32
Not connected
To/From Rear Transition Module (RTM) Connector J32
Intel NetStructure
Description
Section
®
MPCBL0050 Single Board Computer
Technical Product Specification
10.2. After completing
29