MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 191

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Firmware Update Utilities—MPCBL0050
Table 74.
10.5.2
Note:
September 2007
Order Number: 318146-001
Required IPMI command privileges for RMCP bridging (Sheet 2 of 2)
Configuring the Intel NetStructure
This section describes the procedure to configure the Intel NetStructure
0002 Chassis Management Module (CMM) to support RMCP bridging.
The CMM filters individual IPMI commands for bridging based on the
/etc/cmdPrivillege.ini CMM configuration file. (Note that the double “l” in the filename is
spelled this way on purpose.) Each combination of net function and command number
can be given a custom privilege level. Each combination can also be disabled, in which
case the command is not bridged between the LAN and IPMB. This is an example
cmdPrivillege.ini file, which can be modified if needed. Even without modifications, the
file is working and can be used as is.
Copy cmdPrivillege.ini File
On some versions of the CMM firmware, enabling the RMCP server results in an error
for the first 10 to 15 attempts before the server is successfully restarted.
Online Update Get Status
Online Update Get Capabilities
Notes:
1.
2.
1. After the sbcutils installation, copy the cmdPrivillege.ini file from the sbcutils
2. After any change to this configuration file, both CMM RMCP server’s must be
3. To verify the RMCP enable state, use the following command. A “0” indicates
installation path (/usr/share/doc/sbcutils) directory to the CMM’s /etc path. Copy
the cmdPrivillege.ini file to both the active and standby CMMs.
restarted to enable the changes to take effect. To stop and then start the RMCP
server, execute the following commands in sequence. Note, this must be done on
both CMMs at the same time (within 10 to 15 seconds of each other):
disabled and “1” indicates enabled.
# cmmset -d rmcpenable -v 0
Success
# cmmset -d rmcpenable -v 1
Success
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
IMB ERROR Completion Code Error.
# cmmset -d rmcpenable -v 1
Success
This command is needed only when using the reference_sbr script. Not all SBCs support this feature.
This command is needed only if Serial Buffer Reading configuration is enabled in the reference_cfg
script. Not all SBCs support this feature.
IPMI Command
Net Function
30h
30h
Intel NetStructure
®
MPCMM0001/0002 CMM
Command
®
A6h
A7h
MPCBL0050 Single Board Computer
Technical Product Specification
Privilege Required
®
MPCMM0001/
Admin
Admin
191