W83627SF-AW Winbond, W83627SF-AW Datasheet - Page 71

• Manufacturer Part Number: W83627SF-AW
• Manufacturer: Winbond

Specifications of W83627SF-AW

• Pin Count: 128
• Lead Free Status / RoHS Status: Not Compliant

W83627SF
11.1.2 Extended Functions Enable Registers (EFERs)
After a power-on reset, the W83627SF enters the default operating mode. Before the W83627SF
enters the extended function mode, a specific value must be programmed into the Extended Function
Enable Register (EFER) so that the extended function register can be accessed. The Extended
Function Enable Registers are write-only registers. On a PC/AT system, their port addresses are 2Eh
or 4Eh (as described in previous section).
11.1.3 Extended Function Index Registers (EFIRs), Extended Function Data Registers
(EFDRs)
After the extended function mode is entered, the Extended Function Index Register (EFIR) must be
loaded with an index value (02h, 07h-FEh) to access Configuration Register 0 (CR0), Configuration
Register 7 (CR07) to Configuration Register FE (CRFE), and so forth through the Extended Function
Data Register (EFDR).
The EFIRs are write-only registers with port address 2Eh or 4Eh (as
described in section 12.2.1) on PC/AT systems; the EFDRs are read/write registers with port address
2Fh or 4Fh (as described in section 9.2.1) on PC/AT systems.
11.2 Configuration Sequence
To program W83627SF configuration registers, the following configuration sequence must be
followed:
(1). Enter the extended function mode
(2). Configure the configuration registers
(3). Exit the extended function mode
11.2.1 Enter the extended function mode
To place the chip into the extended function mode, two successive wrtites of 0x87 must be applied to
Extended Function Enable Registers (EFERs, i.e. 2Eh or 4Eh).
11.2.2 Configurate the configuration registers
The chip selects the logical device and activates the desired logical devices through Extended
Function Index Register (EFIR) and Extended Function Data Register(EFDR). EFIR is located at the
same address as EFER, and EFDR is located at address (EFIR+1).
First, write the Logical Device Number (i.e.,0x07) to the EFIR and then write the number of the desired
logical device to the EFDR. If accessing the Chip (Global) Control Registers, this step is not required.
Secondly, write the address of the desired configuration register within the logical device to the EFIR
and then write (or read) the desired configuration register through EFDR.
11.2.3 Exit the extended function mode
To exit the extended function mode, one write of 0xAA to EFER is required. Once the chip exits the
extended function mode, it is in the normal running mode and is ready to enter the configuration
mode.
Publication Release Date: May 31, 2005
- 71 -
Revision A1