W83627SF-AW Winbond, W83627SF-AW Datasheet - Page 102

• Manufacturer Part Number: W83627SF-AW
• Manufacturer: Winbond

Specifications of W83627SF-AW

• Pin Count: 128
• Lead Free Status / RoHS Status: Not Compliant

CRE4 (Default 0x00)
CRE5 (Default 0x00)
CRE6 (Default 0x00)
Bit 7
Bit 6 - 5 : Power loss control bit <1:0>
Bit 4
Bit 3
Bit 2
Bit 1 - 0 : Reserved.
Bit 7
Bit 6 - 0 : Compared Code Length. When the compared codes are storaged in the data register,
Bit 7
Bit 6
Bit 5 - 0 : CIR Baud Rate Divisor. The clock base of CIR is 32k Hz, so that the baud rate is 32khz
: Power loss control bit 2.
0 = Disable ACPI resume.
1 = Enable ACPI resume.
00 = System always turns off when come back from power loss state.
01 = System always turns on when come back from power loss state.
10 = System turns on/off when come back from power loss state depending on the state
before power loss.
11 = Reserved.
: Suspend clock source select
0 = Use internal clock source.
1 = Use external suspend clock source(32.768KHz).
: Keyboard wake-up type select for wake-up the system from S1/S2.
0 = Password or Hot keys programmed in the registers.
1 = Any key.
: Enable all wake-up event set in CRE0 can wake-up the system from S1/S2 state. This
bit is cleared when wake-up event occurs.
0 = Disable.
1 = Enable.
: ENS5RST: Enable S5# signal (pin 103) to reset SUSLED mode register (CRF3 of
logical device 9).
= 0SUSLED mode register is reset only by RSMRST#.
= 1SUSLED mode register can be reset by RSMRST# or S5#.
these data length should be written to this register.
: ENMDATUP: Enable an MDAT low pulse to wake up system through PSOUT#.
= 0Disable.
= 1Enable.
: EN_SCUP: Enable SCPSNT# of Smart Card interface to wake up system through
PSOUT#.
= 0Disable.
= 1Enable.
divided by (CIR Baud Rate Divisor + 1).
-102-
W83627SF