CYRF69213-40LFXC Cypress Semiconductor Corp, CYRF69213-40LFXC Datasheet - Page 25

• Manufacturer Part Number: CYRF69213-40LFXC
• Description: IC PROC 8K FLASH 40VQFN
• Manufacturer: Cypress Semiconductor Corp
• Series: CYRFr
• Type: Transceiverr

Specifications of CYRF69213-40LFXC

• Package / Case: 40-VQFN Exposed Pad, 40-HVQFN, 40-SQFN, 40-DHVQFN
• Frequency: 2.4GHz
• Data Rate - Maximum: 1Mbps
• Modulation Or Protocol: ISM
• Applications: General Purpose
• Power - Output: 4dBm
• Sensitivity: -97dBm
• Voltage - Supply: 4 V ~ 5.5 V
• Current - Receiving: 23.4mA
• Current - Transmitting: 36.6mA
• Data Interface: PCB, Surface Mount
• Memory Size: 8kB Flash, 256B SRAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: 0°C ~ 70°C
• Operating Frequency: 2497 MHz
• Operating Supply Voltage: 2.5 V or 3.3 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 1.8V
• Operating Supply Voltage (typ): 2.5/3.3V
• Operating Supply Voltage (max): 3.6V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 770-1001 - ISP 4PORT CYPRESS ENCORE II MCU
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 428-1934

The sources that can drive the CLKOUT are:
■
■
Table 34. IOSC Trim (IOSCTR) [0x34] [R/W]
Table 35. LPOSC Trim (LPOSCTR) [0x36] [R/W]
Document #: 001-07552 Rev. *D
Bit #
Field
Read/Write
Default
The I/OSC Calibrate register is used to calibrate the internal oscillator. The reset value is undefined, but during boot the SROM writes
a calibration value that is determined during manufacturing test. This value should not require change during normal use. This is the
meaning of ‘D’ in the Default field
Bits 7:5
Bits 4:0
Bit #
Field
Read/Write R/W
Default
This register is used to calibrate the 32 kHz Low speed Oscillator. The reset value is undefined, but during boot the SROM writes a calibration
value that is determined during manufacturing test. This value should not require change during normal use. This is the meaning of ‘D’ in
the Default field. If the 32 kHz Low power bit needs to be written, care should be taken not to disturb the 32 kHz Bias Trim and the 32 kHz
Freq Trim fields from their factory calibrated values
Bit 7
Bit 6
Bits 5:4
Important Note Do not program the 32 kHz Bias Trim [1:0] field with the reserved 10b value, as the oscillator does not oscillate at all corner
conditions with this setting
Bits 3:0
CLKIN after the optional EFTB filter
Internal 24 MHz Oscillator
foffset [2:0]
This value is used to trim the frequency of the internal oscillator. These bits are not used in factory calibration and is
zero. Setting each of these bits causes the appropriate fine offset in oscillator frequency
foffset bit 0 = 7.5 KHz
foffset bit 1 = 15 KHz
foffset bit 2 = 30 KHz
Gain [4:0]
The effective frequency change of the offset input is controlled through the gain input. A lower value of the gain setting
increases the gain of the offset input. This value sets the size of each offset step for the internal oscillator. Nominal
gain change (KHz/offsetStep) at each bit, typical conditions (24 MHz operation):
Gain bit 0 = –1.5 KHz
Gain bit 1 = –3.0 KHz
Gain bit 2 = –6 KHz
Gain bit 3 = –12 KHz
Gain bit 4 = –24 KHz
32 kHz Low Power
0 = The 32 kHz Low speed Oscillator operates in normal mode
1 = The 32 kHz Low speed Oscillator operates in a low power mode. The oscillator continues to function normally but with
reduced accuracy
Reserved
32 kHz Bias Trim [1:0]
These bits control the bias current of the low power oscillator.
0 0 = Mid bias
0 1 = High bias
1 0 = Reserved
1 1 = Reserved
32 kHz Freq Trim [3:0]
These bits are used to trim the frequency of the low power oscillator
32 kHz Low
Power
0
R/W
7
7
0
Reserved
–
D
foffset[2:0]
R/W
6
6
0
32 kHz Bias Trim [1:0]
R/W
D
R/W
5
5
0
R/W
D
R/W
D
4
4
■
■
Internal 32 kHz Low power Oscillator except when in sleep
mode
CPUCLK after the programmable divider
32 kHz Freq Trim [3:0]
R/W
D
R/W
D
3
3
R/W
D
Gain[4:0]
R/W
D
2
2
R/W
D
R/W
D
1
1
CYRF69213
R/W
D
Page 25 of 77
R/W
D
0
0
[+] Feedback