UPD78F0413GA-GAM-AX NEC, UPD78F0413GA-GAM-AX Datasheet - Page 151

• Manufacturer Part Number: UPD78F0413GA-GAM-AX
• Description: 8BIT UC, 32K FLASH, 1KB RAM, LCD
• Manufacturer: NEC

Specifications of UPD78F0413GA-GAM-AX

• Controller Family/series: UPD78F
• No. Of I/o's: 30
• Ram Memory Size: 1024Byte
• Cpu Speed: 10MHz
• No. Of Timers: 8
• No. Of Pwm: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 32KB
• Oscillator Type: External, Internal

(2) Capture/compare control register 00 (CRC00)
Note When the valid edge is detected from the TI010 pin, the capture operation is not performed but the
Caution To ensure that the capture operation is performed properly, the capture trigger requires a pulse
CRC00 is the register that controls the operation of CR000 and CR010.
Changing the value of CRC00 is prohibited during operation (when TMC003 and TMC002 = other than 00).
CRC00 can be set by a 1-bit or 8-bit memory manipulation instruction.
Reset signal generation clears CRC00 to 00H.
Address: FFBCH
Symbol
CRC00
INTTM000 signal is generated as an external interrupt signal.
two cycles longer than the count clock selected by prescaler mode register 00 (PRM00).
The valid edge of the TI010 and TI000 pin is set by PRM00.
If ES001 and ES000 are set to 11 (both edges) when CRC001 is 1, the valid edge of the TI000 pin cannot
be detected.
If TMC003 and TMC002 are set to 11 (clear & start mode entered upon a match between TM00 and
CR000), be sure to set CRC000 to 0.
CRC002
CRC001
CRC000
7
0
0
1
0
1
0
1
Figure 6-6. Format of Capture/Compare Control Register 00 (CRC00)
After reset: 00H
Operates as compare register
Operates as capture register
Captures on valid edge of TI010 pin
Captures on valid edge of TI000 pin by reverse phase
Operates as compare register
Operates as capture register
CHAPTER 6 16-BIT TIMER/EVENT COUNTERS 00
6
0
R/W
User’s Manual U18698EJ1V0UD
5
0
CR010 operating mode selection
CR000 operating mode selection
CR000 capture trigger selection
4
0
3
0
Note
CRC002
2
CRC001
1
CRC000
0
151