MC68HC908JL8 MOTOROLA [Motorola, Inc], MC68HC908JL8 Datasheet - Page 52

• Manufacturer Part Number: MC68HC908JL8
• Description: Motorola reserves the right to make changes without further notice to any products herein
• Manufacturer: MOTOROLA [Motorola, Inc]

FLASH Memory (FLASH)
4.5 FLASH Page Erase Operation
Technical Data
52
NOTE:
Use the following procedure to erase a page of FLASH memory. A page
consists of 64 consecutive bytes starting from addresses $XX00,
$XX40, $XX80 or $XXC0. The 36-byte user interrupt vectors area also
forms a page. Any page within the 8,192 bytes user memory area
($DC00–$FBFF) can be erased alone. The 36-byte user interrupt
vectors cannot be erased by the page erase operation because of
security reasons. Mass erase is required to erase this page.
Programming and erasing of FLASH locations cannot be performed by
code being executed from the FLASH memory. While these operations
must be performed in the order as shown, but other unrelated operations
may occur between the steps.
10. After time, t
1. Set the ERASE bit and clear the MASS bit in the FLASH control
2. Read the FLASH block protect register.
3. Write any data to any FLASH address within the page address
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time t
7. Clear the ERASE bit.
8. Wait for a time, t
9. Clear the HVEN bit.
Freescale Semiconductor, Inc.
For More Information On This Product,
register.
range desired.
again.
Go to: www.freescale.com
FLASH Memory (FLASH)
rcv
(1µs)
erase
nvs
nvh
,
(10µs).
(5µs).
the memory can be accessed in read mode
(4ms).
MC68HC908JL8
MOTOROLA
—
Rev. 2.0