s71ws256nc0bawa30 Meet Spansion Inc., s71ws256nc0bawa30 Datasheet - Page 70

• Manufacturer Part Number: s71ws256nc0bawa30
• Description: Stacked Multi-chip Product Mcp 256/512/128 Megabit 32m/16m/8m X 16 Bit Cmos 1.8 Volt-only Simultaneous Read/write, Burst-mode Flash Memory With 128/64megabit 8m/4m X 16-bit Psram.
• Manufacturer: Meet Spansion Inc.

14 Electrical Specifications
14.1
68
+0.8 V
–0.5 V
–2.0 V
Absolute Maximum Ratings
Storage Temperature
Plastic Packages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65°C to +150°C
Ambient Temperature
with Power Applied . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65°C to +125°C
Voltage with Respect to Ground:
All Inputs and I/Os except
as noted below (Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –0.5 V to V
V
ACC (Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .–0.5 V to +9.5 V
Output Short Circuit Current (Note 3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 mA
Notes:
1.
2.
3.
4.
Note:The content in this document is Advance information for the S29WS128N. Con-
tent in this document is Preliminary for the S29W256N.
CC
20 ns
Figure 14.1 Maximum Negative
(Note 1). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .–0.5 V to +2.5 V
Minimum DC voltage on input or I/Os is –0.5 V. During voltage transitions, inputs or
I/Os may undershoot V
Maximum DC voltage on input or I/Os is V
outputs may overshoot to V
Minimum DC input voltage on pin ACC is -0.5V. During voltage transitions, ACC may
overshoot V
voltage on pin ACC is +9.5 V, which may overshoot to 10.5 V for periods up to 20 ns.
No more than one output may be shorted to ground at a time. Duration of the short
circuit should not be greater than one second.
Stresses above those listed under “Absolute Maximum Ratings” may cause permanent
damage to the device. This is a stress rating only; functional operation of the device at
these or any other conditions above those indicated in the operational sections of this
data sheet is not implied. Exposure of the device to absolute maximum rating conditions
for extended periods may affect device reliability.
Overshoot Waveform
20 ns
SS
to –2.0 V for periods of up to 20 ns. See
20 ns
SS
to –2.0 V for periods of up to 20 ns. See
A d v a n c e
CC
S71WS-Nx0 Based MCPs
+ 2.0 V for periods up to 20 ns. See
CC
+0.5 V
+2.0 V
+ 0.5 V. During voltage transitions
1.0 V
I n f o r m a t i o n
V
V
CC
CC
Figure
14.1. Maximum DC
20 ns
Figure 14.2 Maximum Positive
Figure
Figure
Overshoot Waveform
14.1.
14.2.
20 ns
S71WS-N_01_A4 September 15, 2005
20 ns
CC
+ 0.5 V