p2125vps20 Renesas Electronics Corporation., p2125vps20 Datasheet - Page 182

• Manufacturer Part Number: p2125vps20
• Description: 16-bit Single-chip Microcomputer H8s Family / H8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 7 Data Transfer Controller (DTC)
The number of execution states is calculated from using the formula below. Note that Σ is the sum
of all transfers activated by one activation source (the number in which the CHNE bit is set to 1,
plus 1).
For example, when the DTC vector address table is located in on-chip ROM, normal mode is set,
and data is transferred from on-chip ROM to an internal I/O register, then the time required for the
DTC operation is 13 states. The time from activation to the end of data write is 10 states.
7.6
7.6.1
The procedure for using the DTC with interrupt activation is as follows:
1. Set the MRA, MRB, SAR, DAR, CRA, and CRB register information in on-chip RAM.
2. Set the start address of the register information in the DTC vector address.
3. Set the corresponding bit in DTCER to 1.
4. Set the enable bits for the interrupt sources to be used as the activation sources to 1. The DTC
5. After one data transfer has been completed, or after the specified number of data transfers have
7.6.2
The procedure for using the DTC with software activation is as follows:
1. Set the MRA, MRB, SAR, DAR, CRA, and CRB register information in on-chip RAM.
2. Set the start address of the register information in the DTC vector address.
3. Check that the SWDTE bit is 0.
4. Write 1 to the SWDTE bit and the vector number to DTVECR.
5. Check the vector number written to DTVECR.
6. After one data transfer has been completed, if the DISEL bit is 0 and a CPU interrupt is not
Rev. 1.00 Sep. 21, 2006 Page 144 of 658
REJ09B0310-0100
is activated when an interrupt used as an activation source is generated.
been completed, the DTCE bit is cleared to 0 and a CPU interrupt is requested. If the DTC is to
continue transferring data, set the DTCE bit to 1.
requested, the SWDTE bit is cleared to 0. If the DTC is to continue transferring data, set the
SWDTE bit to 1. When the DISEL bit is 1 or after the specified number of data transfers have
been completed, the SWDTE bit is held at 1 and a CPU interrupt is requested.
Number of execution states = I · S
Procedures for Using DTC
Activation by Interrupt
Activation by Software
I
+ Σ (J · S
J
+ K · S
K
+ L · S
L
) + M · S
M