UPD784026 Renesas Electronics Corporation., UPD784026 Datasheet - Page 429

• Manufacturer Part Number: UPD784026
• Description: 16/8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

14.3.5 A/D Conversion Operation Start by Hardware
A/D converter mode register (ADM) to 1. When the TRG bit and the CS bit of the ADM are both set to 1, external signals
are placed in the standby state, and an A/D conversion operation is started when a valid edge is input to the INTP5 pin
(P26 pin).
to the INTP5 pin, the A/D conversion operation being performed at that time is suspended, and A/D conversion is performed
from the beginning in accordance with the contents set in the ADM.
both set to 1 again, the A/D conversion operation being performed at that time is suspended (the standby state is also
suspended), and a standby state is entered in which the A/D converter waits for input of a valid edge to the INTP5 pin in
the A/D conversion operation mode in accordance with the written value, and a conversion operation is started when a valid
edge is input.
operation is started, as soon as one A/D conversion operation ends the next A/D conversion operation is started in
accordance with the operating mode set by the ADM (the A/D converter does not wait for INTP5 pin input), and conversion
operations continue repeatedly until an instruction that writes to the ADM is executed, or a valid edge is input to the INTP5
pin.
An A/D conversion operation start by hardware is made possible by setting both the TRG bit and the CS bit of the
If another valid edge is input to the INTP5 pin after the A/D conversion operation has been started by a valid edge input
If a value is written to the ADM during an A/D conversion operation (CS bit = 1) such that the TRG bit and CS bit are
Use of this function allows A/D conversion operations to be synchronized with external signals. Once A/D conversion
Caution Approximately 10 s is required from the time a valid edge is input to the INTP5 pin until the A/D
conversion operation is actually started. This delay must be taken into account in the design stage.
See CHAPTER 19 EDGE DETECTION FUNCTION for details of the edge detection function.
CHAPTER 14 A/D CONVERTER
389