MSC8103M1100 Motorola / Freescale Semiconductor, MSC8103M1100 Datasheet - Page 39

no-image

MSC8103M1100

Manufacturer Part Number
MSC8103M1100
Description
Network Processor, Networking Digital Signal Processor
Manufacturer
Motorola / Freescale Semiconductor
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MSC8103M1100F
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Part Number:
MSC8103M1100F
Manufacturer:
MOTOROLA/摩托罗拉
Quantity:
20 000
General-
Purpose
PC23
PC22
I/O
CLK9
DMA: DACK1
EXT2
SI1: L1ST1
CLK10
DMA: DREQ1
Peripheral Controller:
Name
Dedicated I/O
Protocol
Table 1-5. Port C Signals (Continued)
Dedicated
Direction
I/O Data
Output
Output
Output
Input/
Input
Input
Input
Communications Processor Module (CPM) Ports
Clock 9
The CPM supports up to 10 clock input pins. The clocks are
sent to the bank-of-clocks selection logic, where they can be
routed to the controllers.
DMA: Data Acknowledge 1
DACK1, DREQ1, DRACK1, and DONE1 belong to the SIU
DMA. DONE1 and DRACK1 are signals on the same pin and
therefore cannot be used simultaneously. There are two sets
of DMA pins associated with the PIO ports.
External Request 2
External request input line 2 asserts an internal request to the
CPM processor. The signal can be programmed as level- or
edge-sensitive, and also has programmable priority. Refer to
the RISC Controller Configuration Register (RCCR)
description in the Chapter 17 of the MSC8103 Reference
Manual for programming information. There are no current
microcode applications for this request line. It is reserved for
future development.
Serial Interface 1: Layer 1 Strobe 1
In the time-slot assigner supported by SI1. The MSC8103
time-slot assigner supports up to four strobe outputs that can
be asserted on a bit or byte basis. The strobe outputs are
useful for interfacing to other devices that do not support the
multiplexed interface or for enabling/disabling three-state I/O
buffers in a multiple-transmitter architecture. These strobes
can also generate output wave forms for such applications as
stepper-motor control.
Clock 10
The CPM supports up to 10 clock input pins. The clocks are
sent to the bank-of-clocks selection logic, where they can be
routed to the controllers.
DMA: Request 1
DACK1, DREQ1, DRACK1, and DONE1 belong to the SIU
DMA. DONE1 and DRACK1 are signals on the same pin and
therefore cannot be used simultaneously. There are two sets
of DMA pins associated with the PIO ports.
Description
1-35

Related parts for MSC8103M1100